Installation
Select the menu language
&Press the MENUbutton on the remote control.
éUse the cursor down to select Installationin the Settings menu.
ŤUse the cursor right to enter the Installation menu.
ŹSelect Languageand enter the list of available languages with the cursor
right.
(Select your language with the cursor up/down and press the OKbutton to
confirm you selection.
§Proceed with the Installation menu.
Store TV channels
&Select Autoprogramin the Installation menu.
éUse the cursor right to enter the Autoprogram menu.
ŤPress the OKbutton.
ŹSelect Cableor Antennain the Installation mode.
When Antenna is selected, the TV will detect antenna signals and will
search for antenna TV (NTSC and ATSC) channels available in your local
area.
When Cable is selected, the TV will detect cable company supplied signals
and will search for cable TV (NTSC,ATSC, QAM modulated) channels
available in your area.
Make sure that registration with your cable TV provider and connection of
equipment are completed.
(Press the green button ONext�on the remote control.
Note:All channels must be unlocked in order to autoprogram.If requested,enter
your PIN code to unlock all channels.See Menu preferences in the Settings,TV
menu,p.15.
§Press the green button OStart�to start autoprogramming.
The menu screen disappears and the progress of autoprogramming is
displayed.The progress bar indicates the number of analog and digital TV
channels found. (Also digital channels via CableCARD are being
programmed. First refer to the CableCARD settings, see p. 18).
When Autoprogramming is complete, a message appears confirming the
completion and the TV switches to the first installed TV channel.
Notes:
YWhen you have locked TV channels while initiating autoprogram,a message
appears asking to enter your PINcode in order to complete autoprogramming.
YATSC channel information is updated automatically when the TV is in standby (after
3 minutes and every 3 hours thereafter).
YWhen interrupted,the updated channel information is retained as well as the not
yet updated old channel information.
YBackground autoprogramming occurs only when the TV is turned on.
YChannel information of an ATSC channel is updated only for the ATSC channel
currently tuned.
YIf an NTSC channel is tuned,then in Background Autoprogramming the TV shall
scan all the possible ATSC frequencies and update information.
YWeak channel installation
This allows you to manually tune weak ATSC channels in order to adjust the
antenna and thus optimize signal quality for that channel.(See Installation menu,
Weak channel installation,p.11.)
YOnce you have searched for as well the available Antenna as well as the Cable TV
channels,they are stored in the memory.
10 |
ACEC
PHILIPS
