2669.3.qxd 15-10-2007 10:26 Pagina 37
TV channels
9Troubleshooting
Some TV channels are gone
YVerify if the correct channel list is chosen.ENGLISH
Television and remote controlYA channel could be uninstalled in the Rearrange
menu.
The TV does not switch on
YVerify the mains cord connection.
YVerify if the batteries of the remote control arePicture
flat or weak.Verify their + / - orientation.
You can use the keys on the TV to switch the TVThere is no picture
on.YVerify if the antenna is connected properly.
Y Unplug the mains cord, wait for one minute andYVerify if the correct device is selected.
plug in the mains again.
The sound is on, but there is no picture
The TV does not react on the remote controlYVerify the contrast or brightness setting in the
YVerify if the batteries of the remote control aremenu.
not empty or weak.Verify their + / - orientation.
Y Clean the remote control and TV sensor lens.The TV picture is poor
Y Use the side control keys to change some of theYVerify if the antenna is connected properly.
basic settings of picture and sound.Y Loudspeakers, non-earthed audio devices, neon
? Press Volume - and + to adjust the volume.lights, high buildings or mountains can influence
? Press Program/Channel - and + to go throughthe picture quality.Try to improve the picture by
the channels marked as favourites.changing the antenna direction or place devices
O Press Menu to show the main menu.away from the TV.
Press Program/Channel - and + to select andYVerify if the correct TV system is chosen in the
adjust picture and sound menu items.Manual installation menu.
Y If only a certain channel is poor, try to fine tune
The red light on the TV blinksthis channel in the Fine tune menu. See section
Y Unplug the mains cord for half a minute and6.2.3.
insert it again.Verify if there is enough space for
ventilation.Wait until the TV has cooled down.The picture has poor colour
When the TV does not restart to standby andYVerify the colour settings in the Picture menu.
the blinking occurs again, call our CustomerSelect any of the Reset to standard settings in
Support Centre.the Reset to standard menu. See section 5.3.2.
YVerify the connections and cables of the
You forgot your code to unlock Child lockconnected devices.
Y See section 5.6.3 Set code / Change code.YVerify if the correct colour system (Automatic,
PAL, Secam, NTSC) has been selected in the TV
Wrong language in the TV menu ?menu > Installation > Preferences > Colour.
Follow these steps to change the language.
? Press Menu on the remote control.The TV did not remember my settings when I
? Press navigation key right.switch back on
O Use navigation key down to highlight the thirdYVerify if the TV is set to Home in the TV menu >
line.Installation > Preferences > Location menu.
? Press navigation key right three times.
o Press navigation key up or down to select yourThe picture does not fit the screen, it is too big or
language.too small
EPress OK.Y Select a more fitting picture format in the Picture
?Press Menu to quit the menus.format menu.
See section 5.3.4 Widescreen picture format.
Y Name your connected device in the Connections
menu to obtain the best signal handling.
See section 7.4.3 Naming your devices.
Troubleshooting37 |
ACEC
PHILIPS
