Installing your television set
Positioning the television set Remote control
5 cm
5 cm5 cm
Place your TV on a solid, stable surface, leavingInsert the two R6-type batteries (supplied)
a space of at least 5 cm around the appliance.making sure that they are the right way round.
To avoid accidents, do not put anything on theCheck that the mode selector is set to TV.
set such as a cloth or cover, a container full ofThe batteries supplied with this appliance do
liquid (vase) or a heat source (lamp).The setnot contain mercury or nickel cadmium. If you
must not be exposed to water.have access to a recycling facility, please do not
discard your used batteries (if in doubt,
Connections
consult your dealer).When the batteries are
replaced, use the same type.
Switching on
FM.
ANT.
Insert the aerial plug into the x socket at
the rear of the set.
If you are using an indoor aerial,reception may beTo switch on the set, press the on/off key.
difficult in certain conditions. You can improveA red indicator comes on and the screen
reception b rotating the aerial.If the receptionlights up. Go straight to the chapter Quick
remains poor,you will need to use an external aerial.installation on page 4.
Insert the mains plug into a wall socket If the television remains in standby mode,
220-240 V/50 Hz). press CH+ on the remote control.
The indicator will flash when you use the
remote control.
The keys on the TV set
The television set has 4 keys which are locatedV
The VOLUME - + (- +) keys are used to
on the top.
adjust sound levels.The PROGRAM - + (- P +)
keys are used to select the required programmes.
+To access the menus, simultaneously hold down
CH
the V - and V+ keys.The CH - + keys may
-M+
then be used to select an adjustment and the
- - V+ k eys to make that adjustment.
To exit from the menus, hold down the 2 V-
and V + keys.
2 |
ACEC
PHILIPS
