37GT-28FP
ELECTRICAL SPECIFICATIONS
"Power Input .......................220V-240 Volts AC 50Hz"Sound Carrier Trap
L?..........................................................40.4MHz
"Power ConsumptionL...........................................................32.4MHz
B/G.......................................................33.4MHz
Normal Operating....................................30W
(Method IEC60107)"Adjacent Sound Carrier Trap
Stand-by Operating................................7.5WL?..........................................................32.4MHz
L, B/G...................................................40.4MHz
"Audio Power Output Rating .....................2W (MPO)"Adjacent Picture Carrier Trap
L?..........................................................41.9MHz
Speaker............................32& 2W, 8cm Round, 1pc
L...........................................................30.9MHz
B/G.......................................................30.9MHz
Convergence.........................Self Converging System
Focus....................................Bi-Potencial Electrostatic"Aerial Input Impedance
VHF/UHF...........................75 ohm Unbalanced
Sweep Deflection...........................................Magnetic
"Tuning Ranges
"Picture Intermediate FrecuenciesL/L?..........................55.75MHz thru 855.25 MHz
L?.........................................................33.9MHz
L, B/G..................................................38.9MHzB/G.........................48.25MHz thru 855.25 MHz
CATV Special Channels
"White Level
Set brightness control to get total picture tube cathode current of 600 uA under no signal condition. Maximum necessary
correction of each picture tube cathode current to get 8950 degree K-20 MPCD screen temperature should not
exceed 15% of its original value.
X=0.290 Y=0.284
Specifications are subject to change without prior notice.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |
ACEC
SHARP
