BM 2610919254 12/02 12/18/02 10:52 AM Page 12
Maintenance
ServiceVentilation openings and switch levers must
Preventive maintenancebe kept clean and free of foreign matter. Do
!WARNING
performed by unauth-not attempt to clean by inserting pointed
orized personnel may result in misplacingobjects through openings.
of internal wires and components whichCertain cleaning agents
could cause serious hazard. Weand solvents damage!CAUTION
recommend that all tool service beplastic parts. Some of these are: gasoline,
performed by a Bosch Factory Service
carbon tetrachloride, chlorinated cleaning
Center or Authorized Bosch Service Station.
solvents, ammonia and household
detergents that contain ammonia.
TOOL LUBRICATION
Your Bosch tool has been properly
lubricated and is ready to use.
Cleaning
To avoid accidents always
!WARNING
disconnect the tool from
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with
compressed dry air. Always wear safety
goggles when cleaning tools with
compressed air.
Accessories
If an extension cord isRECOMMENDED SIZES OF EXTENSION CORDS
!WARNING
necessary, a cord with120 VOLT ALTERNATING CURRENT TOOLS
adequate size conductors that is capableCord Size in A.W.G.Wire Sizes in mm2
ToolOs
of carrying the current necessary for yourAmpere
tool must be used. This will preventRatingCord Length in FeetCord Length in Meters
excessive voltage drop, loss of power or2550 100 15015 30 60 120
overheating. Grounded tools must use 3-3-618161614.75 .75 1.5 2.5
wire extension cords that have 3-prong6-818161412.75 1.0 2.5 4.0
plugs and receptacles.8-1018161412.75 1.0 2.5 4.0
10-12161614121.0 2.5 4.0 N
NOTE: The smaller the gauge number, the
12-161412NNN N NN
heavier the cord.
The length of the vacuum cleaner cord must
be included in calculating the total length of
cord.
-12- |
ACEC
BOSCH
