Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and Your washer can be set to drain
spin for heavily soiled loads which and spin out water.
need more detergent. (Extra de- l Push Control Knob in.
tergent can require an extra rinse.) l Turn clockwise to the bar just before
l Push Control Knob in. OFF in any cycle. See above
l Turn clockwise to any l on the dial. drawing.
See above drawing. l Pull Control Knob out.
l Pull Control Knob out. l The washer will drain and spin.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For agitation and spin speeds in each cycle, see pages 6 -9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l Use recommended amount of
detergent or pre-soak product.
l Push Control Knob in.
l Turn clockwise to point at a number
in the SOAK Cycle.?
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
?Laundry Guide!?
?To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
10 |
ACEC
WHIRLPOOL
