6. Set the TEMPERATURE selector to the correct setting for the Adding bleach to models without a bleach dispenser
type of fabric and soils being washed. Use the warmest water If desired, add measured liquid chlorine bleach after the washer
safe for fabric. Follow garment label instructions.starts agitating. Pour diluted bleach around the agitator, not
Your washer uses automatic temperature control (on some directly onto the load. Undiluted bleach will damage any fabric it
models) to maintain a uniform water temperature by touches. (See ?Adding Liquid Chlorine Bleach.?)
regulating the incoming hot and cold water. This helps Adding softener to models without a fabric softener
eliminate undissolved detergent and ensures consistent
dispenser
cleaning results. The Hot and Warm settings on this washer If desired, add measured liquid fabric softener to the final rinse
will be cooler than you are accustomed to. Wash water. Always dilute fabric softener with 1D? to 1 cup (125 to
temperatures in this washer are lower than the temperatures
250 mL) cup of warm water. Undiluted fabric softener can stain
you may be used to in conventional washers. fabrics. (See ?Adding Liquid Fabric Softener.?)
NOTE: Make sure that both the hot and cold water taps are
fully turned on, or the automatic temperature control feature
Washer Symbols
will not work properly.
The control panel of your washer contains symbols. Refer to the
Water TempUse Forchart below for a definition of those symbols.
HotWhites and pastelsSymbolsSymbols
Heavy soils
Small LoadHand Washables
WarmBright colors
Moderate to light soils
Large LoadSuper Wash
ColdColors that bleed or fade
Light soils
ColdWash
NOTE: In wash water temperatures colder than 60oF Temperature
(15.6oC), detergents do not dissolve well. Soils can be difficult
to remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the WarmQuick Wash
surface of garments).Temperature
7. (OPTIONAL) Some models have an EXTRA RINSE selector.
For an additional rinse and spin at the end of a wash cycle, HotPrewash
set the EXTRA RINSE selector to ON. On some models, the
Extra Rinse feature is part of the cycle. Temperature
8. (OPTIONAL) Some models have an END OF CYCLE SIGNAL
selector. Set the END OF CYCLE SIGNAL selector to ON if TemperatureRinse
you want your washer to alert you when the wash cycle is
complete. The signal is helpful when you are washing items
that should be removed from the washer as soon as the cycle
ends.OnExtra Rinse
9. Push in the Cycle Control knob and turn it clockwise to the
wash cycle you want. Reduce the wash time when using a
small load size setting. See ?Selecting a Cycle and Time.?OffSpin
BuzzerSlow Spin
Pull out the Cycle Control knob to start the washer.CottonCool Down
To stop or restart your washer
To stop the washer at any time, push in the Cycle Control
knob.
SyntheticsPull Start
To restart the washer, close the lid (if open) and pull out Push Stop
the Cycle Control knob.
Delicates
8 |
ACEC
WHIRLPOOL
