INSTALLATION INSTRUCTIONS (continued)
Installation and Cabling
Connecting to a PC
Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safetyIVII
before proceeding to these steps:
1) Make sure that the display signals produced by your PC meet the specifications of this
ENGLISH
product.
" For the specifications of this product, see Product Specifications ( to ).2729
2) Choose an appropriate site and install the product on a level table where the stand is
secure.
" Install the monitor to have ready access to a power socket available.
3) Make sure that your PCs power switch is off.
4) Interconnect the signal input terminal (RGB1) on the monitor rear panel and the display
signal output terminal of the PC to each other using the signal cable included.
" Optional cables are needed to connect to the RGB2 input and audio input terminals.
" If the signal cable included does not match your PC, consult your dealer after reading the
section Signal Input .28
5) Insert one end of the power cable included into the rear-panel power cable connector and
the other end into a power socket.
6) Turn on the monitor, then the PC to make sure that a display image appears on the monitor
screen.
" For instructions on turning on the monitor and adjusting its display images, see
Operating Instructions ( to ).919
Monitor rear panel
Speaker (R)Speaker (L)
Power cable
connector
AUDIO IN
RGB 1
PowerD-SUB INRGB2
cable
VHBGRTo audio input terminals
3.5mm
Stereo
mini jack
To signal
To signal
input
input
terminals
terminalsCord Clamper
When connecting a
computer audio input to
To signal To signal To audio the unit (using a 3.5mm
outputoutputoutputstereo mini jack), the
terminalterminalterminalcord must pass through
the cord clamp toward
the bottom of the back of
PCthe main unit. If it does not,
there is a possibility of
insufficient suppression of
electromagnetic radiation.
6 |
ACEC
HITACHI
