42PMA300EZ (PW1A)
2
ItemPC Color Temperature AdjustmentAdj. pointIC
Adjustment PreparationsAdjustment ProceduresRemarks
(1) This adjustment should be (1)Perform the following adjustment Environment9a20 lux or less
done after video color with the remote control.
temperature adjustment.
(2) Set into Factory Adjustment (2)Set the CRT color analyzer (CA100)
mode.at the center of the panel.
(3) Input : RGB2 [D-sub] (3)Ensure that the adjustments No. 12, Color temperature should
Signal : VGA (75) 0.7V13, 14 are all set as 224.be adjusted under the
(No set up)condition in which the screen
Window ratio : 100%is the brightest, thus the
initial value of adjustment is
it s maximum value.
(4) Confirm that the screen (4)After receiving PC signal, step down Only reducing the brightness
size is Full .the two (or one) among adjustments controls the adjustment, thus
No. 12, 13, 14 and adjust the value weaken the brighter color to
as shown below.adjust.
At least one of the data should be 224.Color temperature is at Cool
mode while the following
No. is selected.
< Specification >Adjustment No. 12, 13, 14
PC color temperature (Cool)
x=0.2680.005
y=0.2830.005
(Color temp:12000K10MPCD)
(5) Write adjustment value of video color temperature to the following NO.
Video Color Temperature PC Color Temperature
No.3 Data No.15 Data
No.4 Data No.16 Data
No.5 Data No.17 Data
No.6 Data No.18 Data
No.7 Data No.19 Data
No.8 Data No.20 Data
No.9 Data No.21 Data
No.10 Data No.22 Data
No.11 Data No.23 Data
25 |
ACEC
HITACHI
