Remote Control Y Working Accessory Devices
SETTINGTHE TV REMOTETO WORK ACCESSORY DEVICES
SEARCH METHOD
Satellite Receiver
our TVremote can be set to work
06
Yvarious accessory devices (VCRs,
07
Cable TV Converter
cable converters, satellite receivers)08
06
by what is called the Search Method.VCR0709
1
NOTE: The Search Method works08
only with devices equipped with0609
Channel Display Indicators or that07
08
capability. If the Direct Access code
093
number method (shown in the previ-
ous section) did not enable your TV
remote to work your accessory device,
then follow the easy steps listed below.
Please read the steps once before per-
forming them.POWER
BEGIN
Turn on the desired device. Press
TVVCRACC
and hold down the VCR or ACCSWAPPIP CHSOURCE FREEZE
DNUP
(for an accessory device other than
SOUNDPICTURE
a VCR) mode button on the TV
2
remote. Then press and hold down theSTATUS/SELECTMENU/4
EXIT
SURF button as you hold down the
NOTE: The remoteOs
desired mode (VCR or ACC) button.
back light will blinkMUTE
VOLCH
as the remote moves
NOTE: You must press and hold
through its product
down the desired mode (VCR or
132
code list. After theACC) button first and then press and
465
remote identifies the
hold down the SURF button second.
product code for your798
TV/VCR
While holding down the SURF accessory device andA/CH0SURF
and the desired mode (VCR oryou release the remote
POSITIONPIP
ACC) buttons at the same time, buttons, the back light
2
point the remotetoward the accesso-will blink twice.
4
ry device and continue holding the
buttons down.
Watch the Channel Indicatoron
your accessory device. Channel num-SMART HELP
bers will scan up when the TV remote
Y Your TV remote may
has identified the correct code for
locate the accessory deviceOs
your accessory device. This may take
code quickly or require several
several minutes.
minutes to do so.
Release the mode (VCR or ACC)YDonOt let the accessory device scan
and SURF buttonsas soon as chan-up more than five channels when
nel numbers start to scan up. Thethe correct code is foundN the
scanning means that your TV remoteremote may pass up the right code
has found the code for your accessoryand have to repeat the search
device. cycle.
YIf no channel change happens after
several minutes, repeat steps 1�4.
Then if a channel change still does
not occur, the remote will not
work the desired accessory device.
46 |
ACEC
PHILIPS
