Connecting a VCR and Cable Box
NOTE: A cable box with AUDIO OUT jacksIncoming
Back of TV
such as the one used in the example on thisCCable TV
2
page might pass stereo sound to the TV. CheckSignal
SERVICE 1
with your cable TV company. The RF jack out-
DVI
G S-VIDEO
put jack on a cable box (commonly labeled
1
RLV
OOUT TO TV,� OOUTPUT,� or OOUT�) willAV1
not pass stereo sound to your TV.Signal
PrPbY
RLV5Splitter
RL
Connect the incoming cable TV signalMONOUT
to a two-way signal splitter. The signalRL
1RLV
splitter enables you to route the cable
G S-VIDEO
signal to the TV without using theAV5AV6
RGB+HV
OUT TO TV jack on the cable box,
SUB OUTAV2
which will not pass stereo sound to theRLPrPbY
STANDARD/2
AV3HD INPUTS
TV.TUNER
STANDARD/PrPbY
AV4RLHD INPUTS
Using a coaxial cable, connect to one4
of the connectors on the signal splitter
2AUDIO
LANT
and to the TUNER jack on the back ofOUT
OUTIN
R
the TV.
VIDEO
IN
OUTINCH3CH4
Using a coaxial cable, connect to the
Back of VCR
other connector on the signal splitter
3(example only)
and to the CABLE IN jack on the backTV
AV1:None
of the cable box.OK
SourceAV2:None
AV3:None
AV4:None
Using Audio/Video cables, connect to
AV5:None
the AUDIO and VIDEO OUT jacks onAV6:None
4SIDE:None
the back of the cable box and to the
corresponding AUDIO and VIDEO INOUTPUT
CH
jacks on the back of the VCR.3 4
CABLETOVIDEORLAUDIO
INTVOUTOUT
Using Audio/Video cables, connect to
3
the AUDIO and VIDEO OUT jacks onBack of Cable Box (example only)
5
the back of the VCR and to the corre-6
7
sponding AV2 audio (L and R) and
video (V) input jacks on the back of
the TV.
Press the Source Select button on theNOTE: Since youOve connected the
remote control to access the Source87cable TV signal directly to the TVOs
6
list.tuner (step 2 above), you can watch
the unscrambled programs by sim-
Press the Cursor Up or Down button toply tuning to the desired channel. To
select the AV2 input source.store channels in the TVOs memory,
7
SOUND CONTROLACITVE PICTUREyou must use Autoprogram, which
you can access through OInstall� in
Press the OK button to confirm your
1 2the TVOs on-screen menu. See the
choice. The set is now switched to theZOOM
8Autoprogram section in the Quick
AV2 input source for the viewing of pro-
Use and Setup Guidethat came with
grams from the cable box or the VCR.
the TV. If you use Autoprogram,
you can select channels by pressing
HELPFUL HINTthe CH + or � buttons on the TV
remote control (in TV mode).
Color Coding Used on Jacks and Plugs to
Otherwise, you must press the digit
simplify connections:
(number) buttons to tune directly to
Yellow: Video (Composite Video)
the channel you desire.
Red: Right Audio
White: Left Audio.
11 |
ACEC
PHILIPS
