How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
* While it is upright. (See Drawing A)Drawing A
* As it is laid down with the screen face down (See Drawing
B). Lay the protective sheet, which was wrapped around
the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen face.
Y This device cannot be installed on its own.
Be sure to use a stand or original mounting
unit. (Wall mount unit, Stand, etc.)
* See page 2.
Y For correct installation and mounting it is
strongly recommended to use a trained,
authorized NEC dealer.
Failure to follow correct mounting
procedures could result in damage to theDrawing B
equipment or injury to the installer.
Product warranty does not cover damage
caused by improper installation.
* Use only Listed Cart or Stand, or mounting
kit or stand provided by manufacturer.
Ventilation Requirements for
Wall
enclosure mounting
To allow heat to disperse, leave space between
50mm (2")50mm (2")
surrounding objects as shown on the diagram
1340mm (52.8") (2")
below when installing.mm
Wall
(34.2")
mm
866
50mm (2")
(2")50
mm
50
1 |
ACEC
NEC
