USING THE REMO TE TO CONTR OL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs .You must first program the remote to match the remote system of your VCR
(refer to page 31 for pre-codes).
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the DVD/VCR button to switch to VCR pre-coded mode.
4. Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 31.
5. Aim the remote at the VCR and press the POWER button.The remote will turn off your VCR when the correct two digit preset code
is entered.When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6. The remote will now control your VCR.
POW ER
TVCBL/SATDVD/VCR
a
SW AP PIP MODE
NO TES:PIPFREEZE
1. If your VCR cannot be operated after performing thePIP CH
VIDEOMENU
OLabove procedures, your VCROs code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated
SELECT
after performing the above procedures, please consult
CONTRc
your VCR operating guide.
LAST CH
TE3. The remote control will remember the codes you haveMUTEEXIT
programmed until the batteries are removed from the
remote control.After replacing the batteries repeat the
entire programming procedure as stated above.
REMOVOLCH
b
THEaDVD/VCR Button
123
This button allows the remote to control your VCR by setting
it to VCR mode.456
789
bPRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.ANT0INFO
For some VCRs , you must press the RECORD button twice
to record a program.
VID1VID2VID3VID4
RECASPECTVIRTUAL HD
cEXCLUSIVE TV ButtonsVID5
These buttons are for operating the TV.
MY VCR CODE IS:
NO TE:Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
28 |
ACEC
HITACHI
