Filter Replacement
ASSISTANCE OR SERVICE
NOTE: The Ţlter indicator lights on top of the air puriŢer will glow
when it is time to replace either the pre-Ţlter or the HEPA Ţlter.
For the most efŢcient operation of the air puriŢer, it is Before calling for assistance or service, please check
recommended that you replace the pre-Ţlter every 3 months and OTroubleshooting.� It may save you the cost of a service call. If
the HEPA Ţlter every year under conditions of normal use and you still need help, contact our service centre.
care. See OReplacement Filters� in the OAssistance or Service� The 1-800 numbers, website, warranty and guarantee statements
section.shown on the carton box do not apply to countries outside the
1. Turn the fan speed knob to Off.U.S.A. Please refer to your local dealer or retailer in your country
for a warranty guide.
2. Unplug air puriŢer or disconnect power.
3. Place Ţngers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it. Replacement Filters
4. Remove and replace the indicated Ţlter. Install the new HEPA Replacement Ţlters are available from our service centre and
Å¢lter in the same direction shown by the arrow located on the from home appliance retailers. The 1-800 numbers on your HEPA
Ţlter frame. Install the new pre-Ţlter by placing it on the tabs. Ţlter are for the U.S.A. only. Please call your local dealer or
retailer for a replacement Ţlter.
NOTE: Do not try to wash and reuse either the HEPA Ţlter or
the pre-Ţlter.Air PuriŢer HEPA FilterPre-Ţlter
5. Place the bottom tabs on the front grille in the slots in the Model No.ReplacementReplacement
base of the air puriŢer. Push the top of the grille forward until Part No.Part No.
the grille locks into place.
6. Plug in air puriŢer or reconnect power.5E (U) AP1501183050 or 11870171183062
7. Turn the fan speed knob to the desired fan speed.5E (U) AP2501183051 or 11870181183062
5E (U) AP3501183052 or 11870211185462
8. Press the Filter Reset button for 5 seconds to turn off the Ţlter
indicator light(s) and reset the timer.
NOTE: Pressing the Filter Reset button before either of the
Å¢lter indicator lights glows will not reset the timer.
TROUBLESHOOTING
First try the solutions suggested here and to possibly avoid
the cost of a service call...
Air puriŢer will not run
Check the following:
Is the air puriŢer turned on?
Is the power cord plugged into a grounded (earthed) outlet?
Has a house fuse blown or has the circuit breaker tripped?
4 |
ACEC
WHIRLPOOL
