SETTINGTHE REMOTE TO WORK OTHER DEVICES - SEARCH
SEARCH METHOD
our TV remote can be set to
Ywork various accessory
SATELLITE RECEIVER
devices (VCRs, Cable Converters,
Satellite Receivers) by what is
called the SEARCH method.
06
Note: The Search Method only
07
works with devices equipped with
CABLE TV08
Channel DisplayIndicators or06CONVERTER
capability. If the "Direct Access"0709
1
code number method (shown in08
the previous section) did not set
09
your remote to work your06
accessory device, then follow theVCR07
easy steps listed below.08
BEGIN
09
1Turn ON the desired device.
Don't let the Accessory Device
Press the correct VCR or ACC
scan up more than five channels
system button on the remote.(in Search mode).
Six Feet
(minimum)
2Stand at least six feet away
from the front of the accessory
device. Point the remotetoward
3
the unit. HOLD DOWN the
SURF and the desired SystemAVPOWER
(VCR or ACC) buttons at the
GUIDEINFO
same time. KEEP HOLDING
BUTTONS DOWN.
TVVCRACC
SWAPPIP CHSOURCEFREEZE
3Watchthe Channel IndicatorDNUP
on the unit. Channel Numbers willFORMATAUTO
SCAN UP when the unit has been
STATUS/MENU/
identified. This may take up toEXITSELECT2
4
two minutes.
VOLCH
4Release the SURF and System
MUTE
(VCR or ACC) buttonsas soon
as channel numbers start to scan132
up. The code has been identified546
and the remote is ready to operate
879
with the accessory device.
100+0SURF
STOPPOSITIONPIP
SMART HELP2
4
Remember, a minute or two
can seem very long, but the
code should be located within two
minutes.
Note: For TV remoteOs equipped
Don't let the accessory device scan up
with a backlight option, the unit may
more than five channels. The remoteOblink� or flash as the remote moves
may pass up the right code and anotherthrough its product code list. Once a
product code has been identified and
two minute search cycle will have to
the buttons on the remote are
be repeated.released, the unit will blink twice.
If no channel change happens within
two minutes, repeat steps 1-4. Should
a channel change still not occur, the
remote will not work with the desired
unit.
46 |
ACEC
PHILIPS
