Installation instructions
Any electrical and/or plumbing work required to installWater supply connections
this appliance should be carried out by a qualified
electrician and/or plumber or competent person.This dishwasher may be fed with either hot (max. 60) or cold
water. Nevertheless we advise you a cold water supply.
Remove all packaging before positioning the machine.
A hot water supply is not always efficient with very soiled
If possible, position the machine next to a water tap and acrockery as it shortens the washing programmes a lot.
drain.
For making the connection itself, the coupling nut fitted to the
machines supply hose is designed to screw onto either a 3/4"
inch gas thread spout or to a purpose made quick-coupling tap
such as the Press-block.
Fitting under a counter
(kitchen worktop or sink)The water pressure must be within the limits given in the
"Technical specifications". Your local Water Authority will
By removing the machines worktop, you can install it under aadvise you on the average mains pressure in your area.
close fitting sink unit or a pre-existing top, providing theThe water inlet hose must not be kinked, crushed, or entangled
dimensions of the recess correspond to those shown in thewhen it is being connected up.
picture.
The dishwasher features fill and drain hoses which can be
turned either to the left or the right to suit the installation by570 - 600
means of the locknut. The locknut must be correctly fitted
to avoid water leaks. (Attention! NOTall models of
dishwashers have fill and drain hoses provided with locknut. In
820this case, this kind of facility is not possible).
If the machine is connected to new pipes or pipes which have
not been used for a long time, you should run the water for a600
few minutes before connecting the inlet hose.
IN05Do not use, for connection, old hoses which have been
used in another appliance.
Proceed as follows:The dishwasher is fitted with safety devices that prevent the
Remove the machines worktop by unscrewing the two rearwash water returning into the drinking water system and
retaining screws, pull the worktop from the back of thecomply with the applicable plumbing regulations.
machine and slide out the front slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
During all operations that involve accessibility to internal
components the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily
accessible for the consumer service department.
If the dishwasher is later used as a free-standing appliance,
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
4 |
ACEC
OTHERS
