54283agb.fm5 Page 4 Tuesday, March 15, 2005 1:16 PM
INSTALLATION
Technical information for the installer
? After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
Do not attempt to lift the oven by the handle. Lift
at the sides as shown in the figure (see arrow).
Check that the appliance has not been
damaged in transit.
Oven dimensions and kitchen unit dimensions
are shown in the figure opposite.
Kitchen units in contact with the oven must be
heat resistant (80° C min).
If plastic laminates or cement are not sufficiently
heat-resistant, warping, bubbling or detachment
of the finish may result.
Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm inside
the cabinet).
Secure the oven to the kitchen unit with screws
(A) as shown.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and doors
(see picture).
4 |
ACEC
WHIRLPOOL
