WHIRLPOOL 6AMTW5955TQ0 Instruction Manual

5. After the washer is in its final location and level, use a 14 mm or y??" open-end wrench to
turn the nuts counterclockwise on the feet tightly against the washer cabinet. Laundry tub drain or standpipe drain
IMPORTANT: If the nuts are not tight against the washer cabinet, the washer may vibrate.
Connecting the drain hose form to the corrugated drain hose
A
Connect Drain Hose
Proper connection of the drain hose protects your floors from damage due to water leakage.
Read and follow these instructions.
The drain hose is connected to your washer and is stored inside the washer cabinet.A.Drain hose reliefs
1. Feed end of drain hose into one end of form. Place end of drain hose form into the drain
Remove drain hose from washer cabinethose relief.
2. Bend the hose over the top of the form and feed into the other end of the form.
Gently pull the corrugated drain hose out of the washer from the top of the hose. Continue to
pull the hose until the end emerges. Do not force excess drain hose back into the rear of the To keep drain water from going back into the washer:
washer. Do not force excess drain hose into standpipe. Hose should be secure but loose enough
to provide a gap for air.
 Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose form on to the corrugated drain hose. You may need additional
parts. See Floor drain under Tools and Parts.Ž
Connect the Inlet Hoses
The new inlet hoses supplied with this machine must be used. Do not re-use old inlet hoses.
Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in
the couplings.
AB
A.Coupling
B.Washer
10