4. Remove the existing door panels, if panels were provided.3. Roll the grille up toward the refrigerator until it snaps into
5. Slide custom door panels into place.place.
NOTE: The freezer door panels may require 1D? in. (3.18 mm)
cardboard fillers behind the panels to keep them from being
loose in that area.
6. Replace the hinge side trims by inserting the notched end
under the top trim first.
7. Tighten the two top trim screws.
Leveling Refrigerator
Your refrigerator has a front and rear roller at the base of the
product on each side. All four rollers can be adjusted from the
front of the product. If your refrigerator seems unsteady or you
want the doors to close easier, adjust the refrigerator's tilt using
the instructions below:
1. Check the installation location to be sure that you have the
proper clearance for the refrigerator. (See the ?Location
Requirements? section.)
2. Plug into a grounded (earthed) outlet.
3. Move the refrigerator into its final position.
4. Open the refrigerator and freezer doors to locate the leveling
bolts at the left and right of the refrigerator base. If your
refrigerator has a base grille, remove it (see ?Base Grille?
earlier in this section).
1. Side Trims
2. Top Trim Screws
3. Door Panels
4. Filler Panels
1. Rear Leveling Bolt (yellow)
Base Grille2. Front Leveling Bolt (silver)
Style 1:
NOTE: The yellow (top) bolt will adjust the rear of the
To remove the base grille:
refrigerator, and the silver (bottom) bolt will adjust the front of
1. Open the refrigerator and freezer doors 90°.the refrigerator.
2. Remove screws from the base grille using a screwdriver.
5. Use a 1D? in. (12.70 mm) socket wrench to adjust the leveling
NOTE: Do Not Remove Tech Sheet that is fastened behind the bolts. Turn the leveling bolt to the right to raise that side of the
base grille.refrigerator or turn the leveling bolt to the left to lower that
side. It may take several turns of the leveling bolts to adjust
To replace the base grille:
1. Open the refrigerator and freezer doors to 90°.the tilt of the refrigerator.
NOTE: Be careful not to unscrew the leveling bolts too much
2. Position the base grille in front of the refrigerator and replace
the screws. when lowering the refrigerator. The bolt head will start to
come away from the refrigerator when in the lowest position.
Style 2:If the screw does come out of the rear roller bracket, the
To remove the base grille:compartment access cover on the back of the refrigerator will
1. Open the refrigerator and freezer doors to 90°.have to be removed to reinstall the bolt.
2. Grasp the grille with both hands.
3. Lift up and tilt the top of the grille toward you.
NOTE: Do not remove the Tech Sheet that is fastened behind the
grille.
To replace the base grille:
1. Open the refrigerator and freezer doors to 90°.
2. Place the lower clips in the openings in the metal panel.
7 |
ACEC
WHIRLPOOL
