Dispenser Lock (on some models)Water Filtration System
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets. Do not use with water that is microbiologically unsafe or
NOTE: The lock feature does not shut off power to the of unknown quality without adequate disinfection before
refrigerator, to the ice maker, or to the dispenser light. It simply or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
deactivates the dispenser levers.
Style 1filterable cysts.
To turn off the dispenser, press the LOCK button until the
indicator appears. The ice and water dispensers will not work. To
Changing the Water Filter
unlock the dispenser, press the UNLOCK button until the
indicator appears. Then continue to dispense ice or water as
The water filter is located in the base grille below the freezer
usual.compartment door. It is not necessary to remove the base grille
to remove the filter.
DISPENSER1. Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
LOCK UNLOCKNOTES:
 Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
Style 2replace the cap and pull the filter straight out.
To turn off the dispenser, press and hold the LOCK OUT button  There will be water in the filter. Some spilling may occur.
until the indicator appears. The ice and water dispensers will not
work. To unlock the dispenser, press the LOCK OUT button until
the indicator disappears. Then continue to dispense ice or water
as usual.
A
B
Water Filter Status Light
The water filter status light will help you know when to change
your water filter. When the status light changes from green to A. Eject button
B. Filter cap
yellow, this tells you that it is almost time to change the water
filter. It is recommended that you replace the filter when the
2. Remove the cap by turning it counterclockwise until it stops.
status light changes to red OR when water flow to your water IMPORTANT: Do not discard the cap. It is part of your
dispenser or ice maker decreases noticeably. The filter should be
replaced at least every 6 months depending on your water quality refrigerator. Keep the cap to use with the replacement filter.
and usage. To change the filter, see ?Changing the Water Filter.? 3. Take the new cartridge out of its packaging and remove the
protective cover from O-rings.
INDICATOR:STATUS:
GOOD (green)New filter installedA
B
ORDER (yellow)Order filter
REPLACE (red) OR Replace water filter
when water flow decreases
After changing the water filter, reset the status light by pressing
and holding the RESET button for 2 seconds. The status light will
change from Replace (red) to Good (green) when the system is A. Protective cover
reset.B. O-rings
4. Place the cap (removed in Step 2) on the new filter. Align the
ridge on the cap with the arrow on the filter. Turn the cap
clockwise until it snaps into place.
38 |
ACEC
WHIRLPOOL
