Fluff Air cycle or Air Only setting Your dryer may have one of the following features:
Use the Fluff Air cycle, or Air Only setting, for items that require WRINKLE SHIELD (automatic)
drying without heat such as foam, rubber, plastic and heat The WRINKLE SHIELD feature automatically activates at the
sensitive fabrics. Set the Cycle Control knob to Fluff Air or select end of the cycle if you do not open the dryer door within a few
Air Only on the Temperature selector and set the Cycle Control minutes. The WRINKLE SHIELD feature periodically tumbles
knob to Timed Drying. This chart shows examples of items that the load without heat for up to 45 minutes.
can be dried using the Fluff Air cycle/Air Only setting.
WRINKLE SHIELD (optional)
Type of LoadFluff Air cycle/Turn the WRINKLE SHIELD feature selector to On to
Air Only setting* periodically tumble the load without heat up to 45 minutes
after the cycle ends.
Foam rubber - pillows, padded bras, WRINKLE SHIELD Plus 30/90 Minute
stuffed toys20 - 30The WRINKLE SHIELD Plus feature selector lets you choose
Plastic - Shower curtains, tablecloths30 or 90 minutes of periodic unheated tumble after the cycle 20 - 30
ends.
Rubber-backed rugs
40 - 50
Olefin, polypropylene, sheer nylon
10 - 20Heavy Dry
Select this setting to evenly dry large or heavy items such as
*(Minutes). Reset cycle to complete drying, if needed. thick cotton bath towels or robes. Set the Temperature selector, if
available, to High Heat.
When using Fluff Air or Air Only
Damp Dry
Check to see that coverings are securely stitched.
Select this setting to dry items to a damp level, or to dry items
Shake and fluff pillows by hand periodically during cycle.that do not require an entire drying cycle. Damp dry items such
as jeans (to prevent stiffness) or cotton clothing (to make
Dry item completely. Foam rubber pillows are slow to dry.
pressing easier). Set the temperature selector, if available, to High
Heat.
Additional Features
?
TUMBLE PRESS setting
This manual covers several different models. Your dryer may not
Select this setting to remove wrinkles from items such as clothing
have all of the features described.
packed in a suitcase or items wrinkled from being left in the dryer
too long. Set the temperature selector, if available, to Medium or
Towels
Low Heat depending on the fabrics in your load.
Select this setting to thoroughly dry extra heavy items such as
mattress pads and quilts or a load of towels. Set the temperature DRYEL? fabric care system
selector, if available, to High Heat.
When using DRYEL fabric care, select the DRYEL cycle setting
and the DRYEL temperature setting. DRYEL fabric care, when
Casual
used in accordance with the manufacturer?s directions, has been
Select this cycle to dry medium to lightweight synthetic, tested and approved for use in full-size dryers built by Whirlpool
permanent press or no-iron items such as, sheets, shirts or Corporation.
dresses. Set the temperature selector, if available, to Medium.
End of Cycle Signal
Delicates
If your model has an End of Cycle Signal, the signal sounds
Select this option to dry small loads or lightweight items. Set the when a cycle is complete. If the WRINKLE SHIELD feature is on,
temperature selector, if available, to Low or Extra Low Heat.
the signal sounds every few minutes. The signal stops when you
open the door or turn the Cycle Control knob to Off.
WRINKLE SHIELD? feature
When you are unable to remove a load from the dryer as soon as
it stops, wrinkles can form. The WRINKLE SHIELD feature
periodically tumbles, rearranges and fluffs the load without heat
to avoid wrinkles. A signal will sound periodically when the
WRINKLE SHIELD feature is on, if the End of Cycle Signal is
selected. The signal and the tumbling will end when you open the
dryer door or turn the Cycle Control knob to Off.
On some models
The End of Cycle Signal is fixed.
OR
The End of Cycle Signal is selectable. The signal will sound
only if the signal is set to On.
Your model may vary from the model shown.
9 |
ACEC
WHIRLPOOL
