TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the Spotted crockery:
fault repeats. Water hardness duly checked and
If the malfunction persists, switch off the regulated?
Salt container empty?
appliance and turn off the water tap. Call our
After-Sales Service. Insufficient detergent?
The appliance will not switch on:Spotted glasses and cutlery:
Power plug properly inserted in the mains Too much rinse aid? (Adjust the rinse aid
socket?regulator to a lower setting).
Power failure?When the appliance will not be used for a
Have you switched the dishwasher on or long period:
have you pressed the On/Off push button? Run twice th?Pre-Rinsee ? programme.
Tap turned on? If not:
Clean the filters.
Turn on the water tap.
Take the power plug out of its socket.
Make sure the water hose filter is not Leave the door ajar to prevent bad odours.
clogged.
Close the water tap.
To do this, turn off the water tap, disconnect
the water hose, clean the filter, reconUpon re-use of the appliance pleanect se follow
the water hose to the tap and turn on thethe following procedur tap.e:
Door closed properly? Open the water tap.
Reconnect the power plug to the socket.
Crockery still dirty after washing:
Have you selected the correct programmNotee?:
Have you used the correct amount of On some models when the On/Off push button is
detergent?pressed, a pre-rinse cycle is performed prior to
Filters clogged or incorrectly assembled?the actual wash programme to regenerate the
Spray arms blocked or nozzles cloggewater softd?ener system.
Salt container cap screwed down?
Crockery loaded correctly? (the water jets
must spray the entire surface of all items).
Filters clogged?
Crockery loaded upside down?
When loading large items in particular, make
sure the water circulates and does not collect
inside them.
AFTER-SALES SERVICE
Before contacting our After-Sales (the number after the
Service:word Service on the
adhesive label)
1. Try to remedy the problem (see
?Troubleshooting Guide?).located inside the
door on the right hand
2. Switch off the dishwasher and restart the side.
wash programme to see if the fault repeats.
If, after carrying out the above checks the
malfunction persists, call our After-Sales
Service and specify: Your name, address
The nature of the problem.and telephone number.
The appliance type and model.
The service number
10 |