SETTING YOUR REMOTE TO WORK VCRS, CONVERTERS - SEARCH
our TV remote can be set to
Ywork your VCR or Cable
Converter by what is called the
CABLE CONVERTER
SEARCH method.
If the "REMOTE CODE" number
method shown in the previous sec-06
tion did not set your remote to07
1
work your VCR or Converter, then08
follow the easy steps listed below.
0609
Please read through steps 1-4
07
before beginning.
08
BEGIN
VCR
1Press the POWER buttonon
09
the VCR or Converter to turn the
unit ON.Don't let the VCR or Converter
scan up more than five channels
Six Feet
(in Search mode).
2Stand at least six feet away(minimum)
from the front of the VCR or
Converter.
Point the remotetoward the unit.3
HOLD DOWN the SURF and
the desired System (VCR or
CBL-Converter) buttons at the
REC lPLAY?STATUS
same time. KEEP HOLDINGCLEAR
BUTTONS DOWN.MENU2
REW!~FF
§§M??4
3Watch the Channel IndicatorPAUSE II
MUTESTOP nSURF
on the unit.
Channel Numbers will SCAN UPVOLCH
when the unit has been identified.
ON/OFFPOSSWAPFREEZE
This may take up to two minutes.
SIZE
4Release the SURF and System100+123
(VCR or CBL) buttonsas soonTV/VCR456
as channel numbers start to scan789ENTER
SLEEP
up. The code has been identifiedSMART0
and the remote is ready to operate
POWERVCRCBLTV
with the VCR or Converter.MODE
STOP
2
4
SMART HELP
Remember, a minute or
two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps
1-4. Should a channel change still
not occur, the remote will not
work with the desired unit.
34 |
ACEC
PHILIPS
