u Power IC, Transistor or Devices Removal/Replacement
1. Heat and remove all solders from the device leads.
2. Remove the heatsink mounting screw (if applicable).
3. Carefully remove the device from the circuit board.
4. Insert new device in circuit board.
5. Solder each device lead and then clip off excess lead.
6. Replace heatsink.
u Diode Removal/Replacement
1. Remove defective diode by clipping its leads as close as possible to diode body.
2. Bend the two remaining leads perpendicularly to the circuit board.
3. Observing diode polarity, wrap each lead out of the new diode around the corresponding lead on the
circuit board.
4. Securely crimp each connection and solder it.
5. Inspect the solder joints of the two Ooriginal� leads on the circuit board copper side. If they are not
shiny, reheat them and apply additional solder if necessary.
TECHNICAL INFORMATION
Model Names 902D 903Ds 904DF
CDT Size19-inch19-inch 19-inch
short length DynaFlat
Diagonal visible image area18-inch
Dot Pitch0.26 mm 0.25 mm
SynchronizationHorizontal 30 - 95 KHz
Vertical50 - 160 Hz
Plug and PlayDDC1/2B/CI
Power SavingEPA, VESA DPMS, Nutek Compliant
Power Source100-240 Vac, 50/60Hz (Free Voltage)
Power Consumption120 W
Dimension(mm)466(W)466(W)466(W)
(set with stand)475.5(H)475.5(H)475.5(H)
464.5(D)408.5(D)465(D)
Weight-unpacked(lbs/Kg)51.8/23.544.0/20.056.2/25.5
Operating Temperature10 ~ 40!C /50 ~ 104!F
6 |
ACEC
DAEWOO
