move air around corners. Choose a window
. Attach seal strips to cabinet. Place 3/8? wide
that?s also near an electrical outlet. (Refer
self-adhering seal strip on window side of bot-
to the ELECTRICAL REQUIREMENT pages
tom flange. Now, starting at the lower corner
for type of receptacle and wiring needed.) Do
of the cabinet, apply 3/8?-wide seal strips
not use an extension cord. The window in
over the center line of the pre-drilled holes for
which you place your air conditioner should
one of the side mounting angles, over the
have an opening of at least 26 inches in width
center line of pre-drilled holes for the top
and at least 20 inches in height (see Figure 4).
mounting channel, and over the center line of
Standard installation parts are supplied for
pre-drilled holes for the other side mounting
double-hung sash windows up to 54 inches in
angle. (See Figure 7.)
width.
Figure 4
3 l Remove front panel by pushing it down and , . _, :.
pulling toward you (see Figure 5). This pro- _,
tects the panel from damage and makes the
air conditioner easier to handle during
installation.
6 l Attach side mounting angles to the sides of
the cabinet by using four hex-head sheet metal
screws (see Figure 8). Punch holes in seal
strip before driving screws. Be sure flange of
each side mounting angle faces inside. Now
attach top mounting angle to cabinet by using
4 l Slide unit out of cabinet. First, disconnect the three hex-head sheet metal screws. Again, be
green ground wire at the left-front corner of sure flange is facing inside.
base of unit by removing retaining screw (save
screw for reuse later). Now slide unit out of
cabinet by pulling out on handle on bottom
(see Figure 6).
?HANDLE
GROUND WIRE SCREW - |
ACEC
WHIRLPOOL
