To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
WARNING
2. Press RESET.
3. Press TEST (listen for click; Reset button will trip and pop
out).
4. Press and release RESET (listen for click; Reset button will
latch and remain in). The power supply cord is ready for
operation.
Electrical Shock HazardNOTES:
Plug into a grounded 3 prong outlet.The Reset button must be pushed in for proper operation.
Do not remove ground prong.The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
Do not use an adapter.
Do not use the power supply cord as an off/on switch. The
Do not use an extension cord.power supply cord is designed as a protective device.
Failure to follow these instructions can result in death, A damaged power supply cord must be replaced with a new
fire, or electrical shock.power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
INSTALLATION INSTRUCTIONS
Unpacking
3. Pull off control knobs (on some models).
WARNING4. Remove front panel from air conditioner and set aside.
5. Remove ground screw and ground wire from front of air
Excessive Weight Hazardconditioner base. Save ground screw.
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.A
Remove packaging materials++
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap +B
over the adhesive with your fingers. Wipe with warm water A.Green ground wire
and dry.B.Ground screw
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These 6. Pull on handle to slide air conditioner out of cabinet. Place air
products can damage the surface of your air conditioner. conditioner on cardboard.
Handle air conditioner gently.
1. Remove air conditioner from carton and place on cardboard.
2. Remove shipping screw from side wall of cabinet.
A
A
A.Handle
NOTE: Do not lift, push, pull or remove any expanded
A.Shipping screw
polystyrene (foam) from inside the air conditioner. It is not
packing material.
5 |
ACEC
WHIRLPOOL
