Electrical Requirements
WARNINGWARNING
Electrical Shock HazardElectrical Shock Hazard
Plug into a grounded 3 prong outlet.Plug into a grounded 3 prong outlet.
Do not remove ground prong.Do not remove ground prong.
Do not use an adapter.Do not use an adapter.
Do not use an extension cord.Do not use an extension cord.
Failure to follow these instructions can result in death, Failure to follow these instructions can result in death,
fire, or electrical shock.fire, or electrical shock.
The portable air conditioner should be connected to a 115 V, To test your power supply cord:
60 Hz, 15- or 20-amp fused grounded 3 prong outlet.1. Plug power supply cord into a grounded 3 prong outlet.
The use of a time-delay fuse or time-delay circuit breaker is 2. Press RESET.
recommended.3. Press TEST (listen for click; Reset button will trip and pop
out).
All wiring must comply with local and national electrical
codes and be installed by a qualified electrician. If you have 4. Press and release RESET (listen for click; Reset button will
any questions, contact a qualified electrician.latch and remain in). The power supply cord is ready for
operation.
Power Supply CordNOTES:
The Reset button must be pushed in for proper operation.
NOTE: Your unit?s device may differ from the one shown.
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
A
Do not use the power supply cord as an off/on switch. The
B
power supply cord is designed as a protective device.
A damaged power supply cord must be replaced with a new
TESTRESET
power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
A.Test button
B.Reset button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense leakage current. If the cord is crushed, the
electronics detect leakage current and power will be
disconnected in a fraction of a second.
5 |