To select the fan speed (Cool or Power Saver mode only):
To operate air conditioner with remote controlPress TURBO, HIGH or LOW.
Turbo
High
POWERFAN
ON/OFFSPEED
Low
Auto Cool
CoolTurboTo set Timer for a 1- to 24-hour delay before air conditioner
turns on (air conditioner must be Off):
Fan OnlyHigh1. Press TIMER.
FAN
SPEEDTimer
Power SaverLow
2. Press the up arrow button to change the delay time from 1 to
24 hours.
3. Press TIMER or wait 10 seconds.
To set Timer for a 1- to 24-hour delay before air conditioner
Temp / Timeturns off (air conditioner must be On):
Timer1. Press TIMER.
2. Press the up arrow button to change delay time from 1 to
24 hours.
3. Press TIMER or wait 10 seconds.
NOTE: Two AA batteries (not included) power the remote control.
Replace batteries after 6 months of use, or when the remote
Changing Air Direction
control starts to lose power. Be sure to install batteries with
correct polarity.Roll the wheel up or down to direct the air left or right. Use the
tab to move the whole cartridge to direct air up, down or straight
To turn the air conditioner on or off:ahead.
Press POWER ON/OFF.
POWER
ON/OFF
1
To raise the temperature:
Press and hold the up arrow button to raise the temperature 1oF
(0.56oC) until it reaches 86oF (30oC). 1. Wheel
1
Temp / Time
To lower the temperature:
Press and hold the down arrow button to lower the temperature
1oF (0.56oC) until it reaches 64oF (18oC).
Temp / Time
1. Tab
To select the mode:
Press AUTO COOL, COOL, FAN ONLY, or POWER SAVER.
Auto Cool - fan speed is adjusted automatically.
Fan Only - fan speed is set to Turbo only.
Cool or Power Saver - fan speed can be adjusted.
Auto Cool
Cool
Fan Only
Power Saver
9 |
ACEC
WHIRLPOOL
