EMPTY/ADJUST BUCKEI light: DRYNESS CONTROL:
Good air circulation is
needed for best If this light is on, the dehumidifier is This controls the amount of moisture in
performance-allow at not running.This light indicates that the room.Turn the control knob
least 12-l 8 inches (30.5 - you need to check: clockwise for more drying.Turn the
45.7 cm) of air space on all l If the bucket is full, empty bucket control knob counterclockwise for less
sides of the dehumidifier. and replace. drying.Turn control knob to?NORMAL?
l If the bucket is not in position, to maintain average humidity
remove bucket and replace. Make conditions.
sure the bucket fits all the way into NOTE: For the first few days of use, turn
the dehumidifier and the light is off the Dryness Control clockwise to
or dehumidifier will not run. ?DRYEST?to remove extra moisture
?...
?... from the furnishings as well as the
?...
. . . . room air. :?
Install dehumidifier on a level floor strong enough to support
the dehumidifier with a full bucket of water.
where the temperature will not fall When moving dehumidifier, use the grip FAN SPEED:
below 65°F (18.3?C). Lower temper-
areas with both hands to push
Some models: this controls fan
atures will cause ice to form on coils.
dehumidifier to a new location. Do not operation. Use desired setting.
lift the dehumidifier with grip area. Pick
HIGH -for faster moisture removal.
dehumidifier UD from the bottom to
LOW - for slower moisture removal.
carry.
If icing occurs, unplug dehumidifier (or
turn off) until ice melts and room
temperature rises. |
ACEC
WHIRLPOOL
