BEFORE USING THE DISHWASHER/
CONNECTIONS
1. Removing the packaging and controls: 4. Electrical connection:
After unpacking, make sure that the dishwasher Closely adhere to local Electricity Board
is undamaged and that the door closes correctly. regulations.
If in doubt, contact a qualified technician or your Voltage information is shown on the rating plate
local retailer.mounted inside the door on the right hand side.
? Keep the packaging materials (plastic bags, The appliance must be earthed as prescribed by
polystyrene parts, etc.) out of reach of children, law.
as they are potentially dangerous. Do not use extension leads or multiple adapters.
This dishwasher has been factory tested to ensure Before carrying out maintenance, disconnect the
it functions correctly. mains plug.
Such testing may leave slight water marks that will If necessary, the power cable may be replaced with
disappear with the first wash.
one the same obtained from our After-Sales
2. Water and electrical connections:Service. The power cable must only be replaced by
a qualified technician.
All water and electrical connections must be
carried out by a qualified technician in compliance
with the manufacturer's instructions (refer to the Warning for models provided with LCD
enclosed installation booklet) and current local display:
safety regulations.The mains plug must be positioned in an easily
The appliance must only be used in the household accessible place.
for the prescribed uses.
For Austria: if the apparatus is series connected to
Do not use the dishwasher if it has been damaged a fault current switch, this must be sensitive to the
in transit. Consult your local retailer or our pulsating current.
After-Sales Service.
(Refer to the separate installation
instructions booklet)
3. Water inlet and drain:
Observe any special regulations issued by your local
Water Board. Water supply pressure: 0,3 - 10 bar.
Make sure the inlet and drain hoses are kink-free
and are not crushed.
If the hose length is not sufficient, please contact
your local dealer or our After-Sales Service.
The inlet hose must be securely clamped to the
water tap to prevent leaks.
The inlet water temperature varies according to
the model installed. Inlet hose marked ?25°C Max?:
maximum temperature 25°C.
All other models: maximum temperature 60° C.
When installing the appliance, make sure the drain
water discharges correctly (if necessary, remove
the wire gauze from the sink siphon).
Fix the drain hose to the spigot with a clamp to
prevent it from coming off during operation.
For appliances with water-stop system only: If the
water connections are made correctly, the water-
stop system safeguards your home against damage
caused by flooding.
4 |