Speaker Connections
FRONTFRONT
SPEAKERSPEAKER
CENTER
SPEAKER
WOOFERSUB
SURROUNDSURROUND
SPEAKERSPEAKER
SUBWOOFERSURROUNDSURROUND
BACKBACK
SPEAKERSPEAKER
Caution: Caution:
To avoid damaging the speakers with a sudden high-levelThe metal portions of the two separate wires should not
signal, be sure to switch the power off before connecting thetouch or an electrical short can occur. Shorted wires can
speakers.create a fire hazard or induce a failure in your equipment.
Check the impedance of your speakers. Connect speaker with
How to connect:
an impedance of 6 ohms or more.
1. Turn the terminal cap counterclockwise to loosen it. The
The black speaker terminals are - (negative).speaker terminal caps cannot be fully removed from the base.
Generally, the + side of the speaker cable is marked to make
it distinguishable from the - side of the cable. Connect this2. Insert the wire into the terminal fully and turn the terminal
marked side to the + terminal and the unmarked side to thecap clockwise to securely connect it:
black - terminal.
Prepare the speaker cables for connection by stripping off
approximately 10 mm or less of the outer insulation.
(Removing too much insulation may lead to a short circuit if
the bared wired should come in contact with each other.)
Twist the strands of the stripped wires tightly together :
Make sure none of the wire insulation is under the terminal,
only the bare, stripped wire.
3. Make sure it is fastened firmly by pulling the cable lightly.
10 |
ACEC
TEAC
