AH/AU-X108E
AY/AE-X108E
AH/AU-X138E
AY/AE-X138E
DISASSEMBLING PROCEDURE
FOR INDOOR UNIT MODEL AH-X108E, AY-X108E, AH-X138E AND AY-X138E
CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY SERVICING
1. Using the narrow slotted screwdriver or similar, remove5. Remove the fastening screw which retains the cable,
the screw cover from the front panel.and remove the cord.
Note: During reassembly, install the holder after
installing the front panel. This will make it
easier to assemble the front panel.
How to remove the screw cover
a. Press the top of the screw cover with the flat-tipped
screwdriver (or nail, etc).
b. Insert the flat-tipped screwdriver (or nail, etc) into6. After closing the open panel, open the horizontal
adjustment louver and pull out the bottom of the front
the lower clearance, and pull and lift it toward you
panel toward you.
for removal.
Lifting the front panel, strongly pull the top toward you.
Making the front panel parallel to the main body,
strongly pull it toward you for removal.
To install the front panel, place the bottom of the front
panel under the open horizontal adjustment louver,
and press in the front panel, parallel to the cabinet.
Screw cover
When pressing it in, take care to prevent the top of the
blow-out port of the drain pan from being caught by the
2. Remove two screws from the front panel.front panel.
7. Remove the unit-to-unit wiring from the terminal board.
(Loosen the screw with the screwdriver, and pull out
the wiring.)
3. Open the open panel, and remove the two air filters.
4. Remove one inner screw.
8. Remove one fastening screw from the control box
Note: During reassembly, donOt tighten the screw
strongly, or it will become idle.cover.
38 |
ACEC
SHARP
