XP AJ 3190/00 22-06-2000 12:11 Pagina 5
AJ3190/00 page 5
CLOCKRADIOALARM
SETTING THE CLOCKSETTING THE ALARM
Important!General
When setting the clock or alarm time, forIf you wish to use the alarm, then you shouldEnglish
accurate hour and minute adjustment alwaysfirst set the alarm time. There is also the choice
make sure you press the HR and MIN buttonsof two modes for waking you up: by buzzer or
separately and not simultaneously.radio. The display will show the alarm indicator
in the bottom left corner if the alarm is set.
Clock display
The time is displayed using the 24-hour clock1. Adjust the clock control to the ALARM
system.position.
1. Adjust the clock control to the TIME SET2. Press and hold down the HR or MIN buttons
position.to set and adjust both the hours and the
2. Press and hold down the HR or MIN buttonsminutes.
to set and adjust both the hours and the� With your finger held down on HR , the
minutes.hours will increase shown as a digit from
� With your finger held down on HR , the00 to 23
hours will increase shown as a digit from� With your finger held down on MIN , the
00 to 23minutes will increase shown as a digit from
� With your finger held down on MIN , the00 to 59
minutes will increase shown as a digit from� If both the HR and MIN buttons are
00 to 59pressed simultaneously, the alarm time
3. Release the HR or MIN buttons when youdisplay will be reset to 0:00.
have reached the correct setting.3. Release the HR or MIN buttons when you
4. To safeguard the clock time from beinghave reached the correct setting.
accidentally adjusted, turn the clock control to4. Adjust the clock control to the RUN position to
the RUN position.return to clock time display.
� To review your set alarm time, adjust the
clock control to the ALARM position.
RADIO
5. To select the alarm mode you wish to be awoken
You can use this clock solely as a radio.by, set the ALARM switch to RAD or BUZ.
1. Set the RAD switch to ON.� If you have selected the radio mode, make
2. Select your wave band using the BANDsure you have adjusted the volume loud
switch.enough to wake you.
3. Tune to desired radio station using the� The buzzer is at a set volume and cannot be
TUNING knob.adjusted.
4. Set the volume by turning the VOLUME control.
5. To turn off the radio, set the RAD switch to
OFF.
To improve radio reception
� For AM, (MW or LW ) the set is provided with
a built-in aerial which to function best should
be placed on a non-metallic surface e.g.
wood, plastic. Direct the MW aerial by
adjusting the position of your clock radio.
� For FM , extend the pigtail wire at the back of
the set completely for optimum reception.
5 |
ACEC
PHILIPS
