AJ3280/00 page 5
CLOCKALARM
SETTING THE CLOCK
Clock display� With your finger held down on 7, the time
English
The time is displayed using the 24-hour clock.will increase rapidly and continuously from
minutes to hours. Release 7 when you
Adjusting the timereach the approximate time setting.
1.Adjust the SET control to the TIME position.� With your finger held down on 4 will allow
2.Press and hold down the 4,7buttons to set
and adjust both the hours and the minutes.you to adjust the time slowly back minute
by minute.
� With your finger held down on 7, the time3.Release the 7or 4buttons when you have
will increase rapidly and continuously fromreached the correct setting.
minutes to hours. Release 7 when you
reach the approximate time setting.4.Adjust the SET control to the RUN position to
return to clock time display.
� With your finger held down on 4 will allow� To review your set alarm time, adjust the
you to adjust the time slowly back minuteSET control to the respective ALARM 1 or
by minute.
ALARM 2 position.
3.Release the 7or 4buttons when you have5.To select the alarm mode you wish to be
reached the correct setting.awoken by, set the respective ALARM 1 or
4.To safeguard the clock time from being
accidentally adjusted, turn the SET control toALARM 2 switch to RAD or BUZ.
�If you have selected the radio mode, make
the RUN position.sure you have adjusted the volume loud
enough to wake you up.
SETTING THE ALARM� The buzzer is set at a fixed volume and
cannot be adjusted.
General
If you wish to use the alarm, then you should
first set the alarm time. Two different alarmALARM OFF
times are possible. This can be useful when, for
example, you need to be awakened at a differentYou can switch off the alarm in three ways:
time during the week and at the weekend. ThereUnless you choose to cancel the alarm
is also the choice of two modes for waking youcompletely, the ALARM RESET option will be
up: by buzzer or radio.automatically selected after 59 minutes from the
The display also indicates whether you havetime your alarm first goes off.
switched on the alarm (s), and these indicators
ALARM RESET
will light up respectively next to ALARM 1 andIf you want the alarm mode to be stopped
ALARM 2 on the displayimmediately, but also wish to repeat the alarm
call at the same time for the following day:
Y Press ALARM RESET during the alarm call.ALARM ON
REPEAT ALARM
1.Adjust the SET control to the ALARM 1 orThis will repeat your alarm call at 6 minute
ALARM 2 position.intervals
2.Press and hold down the4, 7buttons to set
and adjust both the hours and minutes.Y Press SLUMBEROFF/REPEAT ALARM.
Y Press SLUMBEROFF/REPEAT ALARM again
during the next call if you wish to repeat the
alarm call.
5 |