EnglishControlsPower supplyClockRadio
Supplied accessory * CDYRADIOYBUZZERClock memory backup 5 Press CLOCK to confirm the setting.
Line-in cable (used for audio input connec-� selects CD or radio sound sourceWhen a power failure occurs, the completeStandby power consumption
tion) � selects CD radio, or buzzer or alarm modeclock radio will be switched off.When the(clock mode) ........................ 1.5W
( Power cord � connects to wall outlet power supply returns, the time display shows
Controls (see 1)) Pigtail � FM antenna to improve FM 0:00 and you will need to reset the correctRadio
1 REPEAT ALARM � pushes to switch offreception time on the clock.
1 Press POWER to switch on from standby.
alarm for a 6-minute period! Battery compartment � insert a 9 voltTo retain the clock time and the set alarm� The display lights up.
2 LCD Display � shows the clock/ alarm timebattery, typed 6F22 (not supplied) for clocktime(s) in the event of an AC power failure
2 Select RADIO source by pushing
or CD/radio information memory backup or disconnection, insert a 9 volt battery, typedCDYRADIOYBUZZER to RADIO
3 POWER 6F22 (not supplied) into the battery (located on the side panel).
� switches the set on or to standby compartment.This will act as a clock memory� OTUNER� is displayed.
Power supply
� stops the active buzzer, radio or CD alarm1 Check if the power voltage as shown on thebackup.3 Push BAND to FM or MW to select
for 24 hours When powered by the battery, the time willdesired waveband.
type plate on the base of the set corresponds
� switches off the sleep timer to your local power supply. If it does not,not be illuminated on the clock display, and4 Turn TUNING to find your station.
4 ALARM 1/ ALARM 2 operation of the alarms, FM/ MW radio and5 To adjust the sound, turn VOLUME.
consult your dealer or service center.
� sets and activates alarm of ALARM 12 Connect the power plug to the wall outlet.CD are also impossible.As soon as the AC6 To view radio information, press DISPLAY.
power supply returns, the display will indicate
/ALARM 2 The power supply is now switched on and� The current waveband and frequency will
� stops the active buzzer, radio or CD alarmthe numbers on the display shows 0:00.Youthe correct time.be displayed for several seconds (See 2),
1 Insert the battery into the battery
for 24 hours will need to set the correct time.then it will switch back to clock display.
5 CLOCK � sets clock time3 To disconnect the set from the power supplycompartment for clock memory backup.7 To switch off radio and back to standby, press
2 Connect the power plug to the wall outlet.
6 SHUF/REP � selects different CD play completely, unplug from the wall outlet.POWER.
modes: e.g. REPEAT or SHUFFLE Y Replace the battery once a year, or as often� The display lights off.
as necessary.
(random order)The type plate is located on the bottomTo improve reception:
7 / §of the set.Batteries contain chemical substances,soFM: Extend and adjust the pigtail for optimum
� adjusts clock / alarm timethey should be disposed of properly.reception.
� skips CD tracks/ searches for a particularFor users in the U.K.,please follow theMW: Uses a built-in antenna. Direct the
boxed instructions �Important notes...Oon
passage this sheet.Setting the clock antenna by adjusting the position of
your unit.
8 9 � stops CD playback The clock uses 24-hour time format.You may
�erases a CD program set the clock from 0:00 if the set is This set complies with the radio
9 ); � starts/ pauses CD playback disconnected from the wall outlet.interference requirements of the
0 PROG � programs CD tracks 1 Press and hold CLOCK until clock digit forEuropean Community.
!LIFT TO OPEN �lift here to open CD doorhour flashes.
@ DISPLAY � displays CD tracks or radio� It will exit the clock setting mode without
information setting if there is 5-second inactivity.
# AUX � 3.5mm audio input jack 2 Press repeatedly, or hold down / § to
$ TUNING � tunes to a radio station adjust the hours.
% BAND � selects waveband: FM or MW3 Press CLOCK to confirm the hour setting.
^ SLEEP� The clock digits for minute flash.
� switches on/off radio, CD for timer mode4 Press repeatedly, or hold down / § to
� adjusts timer options for radio/CD playback adjust the minutes.
& VOLUME � adjusts sound level |
ACEC
PHILIPS
