Please purchase the appropriate cable for your computer.cause irreparable damage.
Note:? Do not connect both the USB interface cable and the par-?Be sure that the plug in the outlet is readily accessible to
allel interface cable to this unit at the same time.all persons. Power is present in the product even if the
power button is off in order to maintain good copy or print
quality.
Connecting the parallel interface cable
1. Obtain an IEEE1284 shielded parallel interface cable.?To completely shut off the power, first turn off the power
using the "POWER" button. Then unplug the power cord.
2. Ensure that your computer and unit are turned off.
3. Insert the cable into the parallel interface connector lHoowcat ted on to deal wheith error messages during the initial
rear of the unit, and fasten with clasps.setup
The following messages may appear on the display panel when you
turn on the unit for the first time after purchasing.
Unable to Copy,
Missing print head
Shipping Lock is on;
Unlock to operate
4. Insert the other end of the cable into the interface connector of
your computer.These error messages will remain until the setup process is complete.
When any of other error messages appears, refer to "CANCELLING
Connecting the USB interface cableAN ERROR MESSAGE".
Note:? USB is available with a PC/AT compatible computer that
was originally equipped with USB and had Windows 98
preinstalled.6. INSTALLING THE PRINT HEADS AND
1. Obtain a shielded USB interface cable.THE INK TANKS
2. Insert the cable into the USB interface connector located on the
Note:? This section describes how to install the print heads and
rear of the unit.ink tanks when you install them for the first time after
purchasing this unit. Refer to "THE INK TANK" or "THE
PRINT HEAD" when they need to be changed.
1. Make sure that the scan head locking switch is released.
Refer to step 3 of "UNPACKING".
2. Make sure that the power is on.
3. Load paper following the steps shown in "LOADING PAPER".
4. Turn the front cover locking knob with one hand and lift the front
cover with the other hand, while keeping the knob in the unlocked
3. Insert the other end of the cable into the interface connector ofposition.
your computer, or the USB hub connected to your computer.
5. CONNECTING THE POWER CORD
1. Insert the power cord into the socket on the rear of the unit.
Do not move the
carriage manually by
force.
Note:? Keep the front cover open securely while installing print
heads and ink tanks. You may get your hand caught be-
2. Connect the other end of the power cord to an outlet.tween the body and the front cover of the unit if you install
The unit will be turned on automatically.them with the front cover half open as shown in the illustra-
tion with "X" marked.
Auto Shut Off
The unit automatically turns off the power when 60 minutes past after
the last operation. Press the "POWER" button to turn on the unit
again.
Note:? Do not connect the unit to other than 100V-240V outlet.
Plugging the unit into an incompatible power supply may |
ACEC
SHARP
