Viewfinder screen status displays
1Extender display :Camera warning/information display
This appears when the lens extender is being used.The black balance, white balance, auto knee
function, super iris, super gain and other alarm
2Shutter speed/mode display displays and warnings appear here.
This indicates the shutter speed or shutter mode
setting.;Safety zone markers
OOFF (no display):These indicate the 80% or 90% (factory setting)
The shutter is not used.range of the surface area of the viewfinder screen.
O1/100, 1/120, 1/250 1/500, 1/1000, 1/2000:The display range proportion is set on the VF
Shutter speeds (sec.) in the standard modeDISPLAY screen of the setting menu.
O1/60.0 to 1/251.3 (SYNCHRO SCAN):For details, refer to OSetting the marker displays�
Selection of synchro scan mode(page 44).
3Remaining tape display <Center marker
During recording, this shows the remaining tape (inThis indicates the center of the viewfinder screen.
minutes) in the VTR. When less than two minutesThe display is set ON or OFF on the VF DISPLAY
of tape remain, the figure starts flashing.screen of the setting menu.
4Battery voltage display =Super iris ON display
This indicates the battery voltage (V) duringOS� appears when the super iris is ON.
operation. The voltage is displayed as a
percentage when a digital battery is used.>Zoom position display
The distance from the WIDE end to TEL end of the
5Filter displayzoom lens is indicated here as a number from 0 to
This indicates the type of filter selected.99.
6White balance memory display ?TCG display
This indicates the automatic adjustment memoryThis indicates the time code generator value.
selected for the white balance.
A: The WHITE BAL switch has been set to OA.�@Master gain setting display
B: The WHITE BAL switch has been set to OB.�The GAIN L/M/H values currently set appear here
P: The WHITE BAL switch has been set to OPRST.�when the MODE CHECK button is pressed.
7Gain displayAColor temperature display PRE/A/B
This indicates the gain (dB) of the video amplifierThis indicates the color temperature when AWB is
which was set using the GAIN switch.executed using white balance memory A or B.
8Audio level displayBBattery type
This indicates the audio level (which can beThis indicates the type of battery selected.
displayed separately for audio CH1 and CH2).
During sine wave input, it roughly corresponds withCTotal tape length
the VTROs level meter as shown below.This indicates the total length of the cassette tape.
+Audio level display
DPreset color temperature display
VTROs level meter-40-30-25-18/20-15-10-50
This indicates the preset white balance value.
9Aperture display
EVTR warning/information display
This indicates the approximate aperture setting (F
Alarm displays such as SLACK, REC WARNING,
number).
HUMID, SERVO and RF as well as other warnings
<Note>
are indicated here.
This appears when a lens with an aperture display
function is being used.
FInterval recording mode display (flashing)
GAUDIO CH1/CH2 input display
The input signals to be recorded in audio channels
1 and 2 are indicated here.
41 |
ACEC
PANASONIC
