ó 1
�?´
Recording(continued)
Scene-to-scene continuity
If the unit is in the rec-pause mode, it is possible toEnsuring scene-to-scene continuity at
ensure scene-to-scene continuity with an accuracy ofother times
0 up to 1 frame just by pressing the VTR START
button or lens VTR button.Proceed as follows either after the tape has been
If the unit is in a mode other than rec-pause, the pointallowed to run or after the cassette has been ejected
at which the scene-to-scene continuity is to beor when ensuring continuity on a tape which has been
maintained must be located before recording isrecorded only in part.
started.
1While monitoring the viewfinder screen, press the
During rec-pausePLAY/PAUSE button to play back the tape.
The scene-to-scene continuity timing is located
automatically. However, the time taken until the startAt the place on the tape where continuity is to be
2
of recording differs depending on the setting of themaintained, press the PLAY/PAUSE (or STOP)
VTR SAVE/STBY switch.button again to stop the tape.
OWhen the VTR SAVE/STBY switch is set to SAVE,
recording commences about two seconds after the
VTR START button is pressed.3Press the lens RET button.
No playback images are shown, but two or so
OWhen the VTR SAVE/STBY switch is set to STBY,
seconds later preparations are made for shooting
recording commences as soon as the VTR START
with scene-to-scene continuity.
button is pressed.
To check whether the tape has been cued up to
the place where shooting with scene-to-scene
Ensuring scene-to-scene continuity aftercontinuity is to start, press the RET button again.
the power was turned off while the unit
was in the rec-pause modePress the VTR START button or lens VTR button
4
to start the recording.
1Switch the power back on.
1,23
Press the VTR START button or lens VTR button
2
to start the recording.
4
21
The functions of a VTR START/STOP button can be
assigned to the USER1 or USER2 button on the
units side panel on the CAM SW MODE screen of
FILM (CAM) MAIN MENU 2, and this button can
then be used to perform the start and stop
operations.
83 |
ACEC
PANASONIC
