Setup menus
USER menu<TIME CODE>
No./ItemDescriptionNo./ItemDescription
511This selects how the VITC which is to be514This selects whether or not to record the
superimposed onto the output video signal isinternal time code generator value in the
VITC OUTto be output.VITC GENVAUX area.
0000SBC:0000OFF:
During recording:The internal time code generator value is not
The input time code, which was selected byrecorded in the VAUX area.
the setup menu No. 505 (EXT TC SEL)When video signals on which the time code
setting and TCG switch, is output as thehas been recorded are input, the time code of
VITC.the input signals is recorded in the VAUX area.
During playback:0001ON:
The time code recorded in the SBC area isThe internal time code generator value is
output as the VITC.recorded in the VAUX area.
0001VAUX:<Note>
During recording:If SDTI/1394 has been selected as the input
The time code detected from the input videosignals using the INPUT SELECT button, the
signal is output as the VITC.time code on the input signals will be recorded
During playback:regardless of this menuOs setting.
The time code recorded in the VAUX area is
output as the VITC.SBC (sub code data) area:
<Note>
The time code detected from the input videoThis area is separate from the video and audio data area on the
signal is automatically recorded in the VAUX areahelical track. The time code complying with SMPTE/EBU standards
is stored here. As with the conventional LTC (linear time code), the
while pictures are being recorded.time code can be read even during rewinding or fast forwarding. It
512This selects how the phase alignment for thecan also be read out when the tape has stopped.
time code output from the TIME CODE OUT
TC OUT ADVconnector is to be handled.VAUX (video auxiliary data) area:
Usually, it is aligned with the output video andThis area is to be found in the video data area on the helical track.
audio signals.The additional information relating to the video data is stored here.
However, when external components are to be
connected, it is possible to align the phase with<Note>
the input signal.The time code and userOs bit are controlled during tape playback by
the data which has been recorded in the SBC area. This means that
0000OFF:all the data recorded in the SBC area alone is used as the data
Phase alignment is not performed. which is to be indicated on the counter display section in the middle
The time code output from the TIME CODEof the front panel or in the superimposed display, or as the data
OUT connector is aligned with the output videowhich is to be transmitted to the editing controller or other unit.
and audio signals.
0001EDIT:
When editing mode has been selected, the
time code output from the TIME CODE OUT
connector is aligned with the input video and
audio signals during playback and editing
operations.
In all other modes it is aligned with the output
video and audio signals.
513This sets the operation mode which is to
make the internal time code generator
RUN MODEadvance.
0000REC:
The internal time code generator is advanced
during recording.
0001FREE:
When the power is on, the internal time code
generator is advanced regardless of the
operation mode.
The underlined items indicates the initial setting.
44 |
ACEC
PANASONIC
