#,52%--2
'PINKUJ DQQMMo+9Ţ9�9�9â9á?9�9�a?�?a?
? e9a(9a9á 1
Chapter 5 Preparation (continued)
5-1-2 Use of the external DC power supply5-2 Mounting the Viewfinder and
Adjusting its Position
1Connect the external DC power supply to the DC IN
socket on the unit.Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other
than models AJ-VF15B or AJ-VF20WB.
z If you need to buy a slide rail, please contact the store
where you purchased the camera-recorder and tell them
that the slide rail is a repair part.
Slide rail (VFC3995)
Screws (XBS3+8VZ)
Mounting the Slide Rail5
1Undo the upper two screws for AJ-VF15 or AJ-VF20W,
DC IN Socket
and remove the mounting unit.
Leave the screws attached to the mounting unit.
External DC
power supply Mounting unit
Screws
2Turn ON the power switch of the external DC power
supply. (If the power switch is available on the external
DC power supply)
3Turn ON the POWER switch on the unit.
Rush current may occur at the time for turning on the
power of the unit. We recommend using an external DC
power supply capable to secure double or more
capacity of the total power consumption of the devices
connected to the unit such as the viewfinder and lights.
Use a DC cable with a capacity of 10A or more.2Mount the slide rail, then tighten the two screws.
Slide rail
Confirm the pin arrangements of the DC output connector
of the external DC power supply and the DC IN socket on
the unit, and connect the proper polarities to each other.
If the +12 V power supply is connected to the GND
connector in error, it may cause a fire or failure of the unit.
Pin No.Signal
41GND
1
232, 3?
4+12V
DC IN Socket
<Notes>
z If both the battery pack and the external DC power
supply are connected, the electric power is supplied
from the external DC power supply. While the
external DC power supply is used, the battery can be
mounted and removed on/from the unit.
z When the external DC power supply is used, ensure that
the power switch of the external DC power supply is
turned on first and then the POWER switch on the unit is
turned on. In the case of the reverse operation, a
malfunction may occur on the unit since the output
voltage of the external DC power supply is raised slowly.
z When connecting a battery to the DC IN socket,
select the battery type listed under EXT DC IN
SELECT. Select EXT DC IN SELECT from the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page. In this case, however, the %
display is disabled, even when using a digital battery.
67 |
ACEC
PANASONIC
