OUTPUT SEL (output signal selection) switchUSB 2.0 connector
Used to switch the signals output from the VIDEO OUT andA USB 2.0 cable is connected here. (To be supported in the
MON OUT connectors. near future.)
MEM:In EE (recording) mode, video from the camera is
GENLOCK IN connector
output. In VV (playback) mode, playback signal
2from a P2 card is output. This connector is used to input a reference signal when the
CAM:Video from the camera is output constantly.camera unit is gen-locked, or when the time code is
externally locked. If VIDEO is selected for the menu option
OFF:Video is not output, and the video camera-
recorder operates in power-saving mode. REC SIGNAL, the connector can be used to record actual
signals. The menu option REC SIGNAL is found on the
Note that the audio output is synchronised with the video.SYSTEM MODE screen on the SYSTEM SETTINGS page.
For types of video outputs, see [4-9-2 Selecting Video
Output Signals].<Notes>
z The reference input signal must be a standard VBS
REW (rewind) button and lamp(Video Burst Sync).
During pause, this button performs a fast-reverse playbackz If you need to synchronise the input signal with the AJ-
SPX800P when VIDEO is selected for the REC SIGNAL,
with the lamp blinking.
During playback, it performs an approximately 4C fast-set the menu option GENLOCK to EXTŽ. The option
reverse playback with the PLAY and REW lamps blinking.GENLOCK is found on the GENLOCK screen, which is
accessible from the SYSTEM SETTING page.
If this button is pressed when playback is paused, the start
of the clip being played back is located in pause mode.
MON OUT (monitor output) connector
FF (fast forward) button and lampThis connector outputs the video signal to the monitor. The
During pause, this button is used to perform fast playbackvideo signals linked to the setting of the OUTPUT SEL
with the lamp blinking.switch are output from here. Through an internal menu
option, the characters can be superimposed independently
During playback, it performs an approximately 4C fastof the VIDEO OUT connector. For more information, see [4-
playback with the PLAY and FF lamps blinking.
If this button is pressed when playback is paused, the start9-2 Selecting Video Output Signals].
of the next clip is located in pause mode.
Connector cover
STOP buttonThis cover must be removed in order to attach the optional
This button stops playback.connector 1394. For directions on attaching the connector,
see the instruction manual for the optional connector 1394.
PLAY/PAUSE button(To be supported in the near future.)
This button is used to view playback using the viewfinderECU REMOTE (remote control) connector
screen or a color video monitor. The lamp comes on when
playback starts. The extension control unit AJ-EC3P (optional accessory) is
In playback mode, this button pauses (PLAY PAUSE)connected here.
playback with the lamp blinking.
VIDEO OUT (video signal output) connector
REC buttonThis connector outputs video signals. The video signals
Pressing this button starts recording, and pressing againlinked to the setting of the OUTPUT SEL switch are output
stops recording.from here.
This button has the same function as the REC START/
STOP button and the VTR button at the lens.
It may be disabled with the recording protection button.
REC protection button
This button disables the REC button on the handle.
ON: The REC button is enabled.
OFF: The REC button is disabled.
P2 CARD STATUS LED
This LED indicates the recording and playback status of
each card.
Slide lock button
Used to open the slide-out door for inserting P2 cards. While
depressing this button, slide the door to the left.
15 |
ACEC
PANASONIC
