NC
INSTALLATION
Electrical and mechanicalThe manufacturer cannot be held
responsible for any injury to persons or
connection
animals or damage to property arising
xTheelectricalconnectionsmustcomplywithfrom failure to comply with these
local regulations.requirements.
xThedatarelevanttothevoltageandpowerxWhenthecookinghobisinstalled,provide
absorption are indicated on the rating plate.a singleîpole circuit breaker with a contact
xTheearthingofthisapplianceiscompulsorybreaking distance of at least 3 mm.
by law.
Connection to gas supply
The gas supply system must comply with
current local regulations.
The connection of the cooking hob to the gas pipe
networkorgas cylindermustbemadeby means of
a rigid copper or steel pipe with fittings complying
with local standards, or by means of a continuousî
surface stainless steel hose complying with local
standards. Interpose gasketb in the elbow
connection.b
a
Themaximum length of thehoseis2m.
Important: if a stainless steel hose is used, it
must be installed so as not to touch any
movable part of the furniture. It must pass
through an area where there are no
obstructions and where it is possible to inspect
it on all its length.
Connection and installation
Oven and cooking hob with universal joints
b
Afterhavinginstalledand fixedthe cookinghob,
install the oven.a
1. Connect tonguesa to endb,asshown in the
figure.
2. If the cooking hob is equipped with an electric
hotplate, connect 3îplug assemblyr to the first
3 bores of the 5îpole terminal board on blocka,
as showninthe figure.
3. Position the oven and fix it with the screws
supplied.r
r
4. Fit the knobs, pressing them into their seats on
the control panel.
aa
Note
If the cooking hob must be connected to the Box
instead of the oven, read the instructions supplied
with the Box.
57
MY
57 GB 68461 |
ACEC
WHIRLPOOL
