NC
INSTALLATION
xInstallationmustcomplywithcurrentlocal
Technical information for installer
This cooking hob can be embedded in aregulations.
worktop 20 to 50 mm thick. If there is no ovenxIntheroomwherethecookinghobisinstalled,
there must be enough air to allow the gas to
beneath the cooktop �any oven installed mustburn correctly �see relevant tableO.
be manufactured by us and equipped with axThenaturalflowofairmusttakeplacethrough
cooling systemO, insert a separator panel at aan adequate opening, that must be:
minimum distance of 20 mm from the bottomî permanent, made on one of the outside walls
of the cooktop.of the room, and communicating with the exterior
Note: before installation, make sure that thein an area away from sources of pollution;
local gas delivery conditions �nature andî built so as to ensure that its openings, both on
pressure of gasO are compatible with thethe inside and on the outside, cannot be
settings of the cooking hob, as indicated onobstructed, intentionally or accidentally;
the rating plate.î protected by a metal grid or mesh that does
xIfaverticalpieceoffurnitureisinstalled,not reduce its working section;
there must be a gap of at least 100 mmî situated near the floor level and positioned so
between it and the edge of the cookingas not to interfere with the operation of the fume
hob.exhaust devices.
xBeforeinstallingthecookinghob,removethe
plastic film that protects it, if present.
The outer surfaces of the furniture or appliances
adjoining the cooking hob must be heat resistant
�heat protection oYóO according to standards.
Assembly
xApplythesuppliedgaskettothecooking
hob �unless it has already been fittedO, after
having cleaned its surface as shown in the
relevant figure.
To fasten the cooking hob, use bracketsa
supplied with it.
1. Fit the brackets into the relevant bores and fasten
them by means of their screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
Important: the power supply cable and plug
must be suitable for the power absorption of
the cooking hob, and the cable must be long
enough to permit the upward extraction of the
cooking hob.
56
MY56 |
ACEC
WHIRLPOOL
