3gb66074a.fm Page 7 Thursday, September 1, 2005 4:34 PM
CARE AND CLEANING
Important: Do not use water pressure cleaners or steam cleaners.
Exterior of the oven
Clean with a damp cloth. If it is very dirty, add a few drops of
washing up detergent to the water. Wipe with a dry cloth.
Do not use corrosive or abrasive detergents, which dull the surface.
In the event that one of these products comes into contact with the
oven, immediately clean it using a damp cloth.
Slight differences in colour on the front of the appliance are
determined by the different materials used, such as glass, plastic
and metal.
Accessories
Soak the accessories in water with washing up detergent
immediately after use. Food residues can be easily removed using a
brush or sponge.
Oven cavity
Do not use abrasive cleaners or pan scourers. Use special oven
cleaners and follow the manufacturer's instructions.
After every use, wait for the oven to cool then clean it to prevent
the build-up of baked-on food residues.
With long cooking times or when cooking on different levels,
especially food with a high water content (pizzas, stuffed
vegetables, etc.) condensation may form on the inside of the doors
and the seal. When the ovens are cool, dry the inside of the doors
with a cloth or sponge.
Clean the glass of the doors with a suitable liquid detergent.
Replacing the bulb
Warning: Disconnect the appliance from the power supply.
To remove the side runner frame, push it simultaneously down and
towards the centre of the oven (A-fig.1). Then lift the side runner frame
upwards to release it from the cavity wall (B-fig.1).
Prise off the glass cover C using a screwdriver E.
Fig. 1
Change the lamp D (fig. 2).
Note: use only 25 W/230 V, E-14 type, T300°C bulbs available from
After Sales Service.
Refit the glass cover, pressing it slightly (fig. 2).
To refit the side runner frame, follow the steps above in reverse order.
Removing the oven doors (for cleaning)
To facilitate cleaning, the oven door can be removed as follows:
Hinges F are provided with two movable bolts G.
When bolt G is raised, the hinge is released from its housing. Having Fig. 2
done this, the door must be lifted upwards and removed, sliding it
outwards; hold the sides of the door near the hinges when performing
these operations.
To refit the door, insert the hinges into their seats and open the door
fully.
Remember to rotate the two movable bolts G used to hook the two
hinges before closing the door (fig. 3).
WARNING
Take care not to dislodge the hinge lock system when removing
the door as the hinge mechanism has a strong spring system!
Do not immerse the door in water at any time.Fig. 3
7 |
ACEC
WHIRLPOOL
