NC
GAS COOKTOP
AKR 001 AKR 003 AKR 013
GAS BURNERSTo light one of the burners:
The flow of gas to the burners is adjusted bythe1. Press and turn the gas tap knob anticlockwise to the
knobs which control the taps with safetyvalves.maximum flow position, press it down and keep it
pressed.
Match the mark on the knob with the symbols printed2. Press the electric ignition push-button. If there is a
on the panel:power cut use a flame.
-fulldiscx=tap off3. Wait for ten seconds after lighting the burner before
releasing the knob (valve triggering time).
- symbola= max. opening or max. flow4. Set the gas tap to the position required.
- symbola= min. opening or min. flow
If particular characteristics of the locallysupplied gas
make lighting the burner with the knob in the
maximum flow position difficult, repeat the operation
with the knob in the minimum flow position.
If the burner flame should go out for anyreason, the
safetyvalve will automaticallyshut off the gas supply.
To light the gas again, turn the knob to thex position
and then repeat the lighting operations.
The maximum flow is used to bring liquids to the boil
quickly, while the low flow is used to heat food slowly
or for simmering.
All the operating positions must be chosen between
the maximum and the minimum and never between
the maximum and the OFF.
33
MY
33 |
ACEC
WHIRLPOOL
