Assembly Instructions
CAUTION1 Assembling the stand
Y Take particular care to avoid injury when installing legs and
pedals, and when mounting the keyboard onto the stand.Refer to Figures 3, 4 and 5 as you assemble the stand according to
Y When assembling, make sure that the sliding keyboard cover ofthe following procedure.
the digital piano body is completely closed. If the cover is left
open during assembly, it may close suddenly causing the fingers
Figure 3
to be pinched between the digital piano body and cover.
IMPORTANT!E
Y Be sure to assemble the stand on a flat surface.I
Y This stand does not include any of the tools required to assemble
it. You should have a large Phillips head (+) screwdriver on hand
C
for assembly.
I
AE
I
Figure 1
D
�4EE
C�6F
A�1GSide upright
�2H3
B
�4IB
Crosspiece
2
D
Attach side uprights A and B to crosspiece D using
1
the four E screws (Figure 3).
Y Check the items that come with the unit to make sure thatY When joining the two pieces marked 2, the metal pieces
everything shown in Figure 1 (A through I) is included.3 on the insides of side uprights A and B should fit into
All screws are in a plastic bag inside of the packing cardboard.the slots at the ends of crosspiece D. Make sure the metal
pieces are pushed into the slots as far as they will go. If
they are not, the metal pieces 3 and the screws E will not
Figure 2
match up correctly, which can cause stripping of the
1screws.
Y Before starting actual assembly of the stand, undo the clip at
location 1 (Figure 2) where the pedal cable comes out the back
of crosspiece D.
429A-E-039AE-37
AP80R_e_29-41.p653704.8.26, 3:44 PM |