AQ 6688 /00 - page 6
SETTING THE CLOCKRADIO RECEPTION
EnglishCHANGING THE TUNING STEPS AND 12/24-HR CLOCK
1Connect the headphones to the psocket.
In North and South America the frequency step between2To switch on the radio and select your waveband:
adjacent channels in the AM (MW) band is 10 KHz. In theY press RADIO ON-OFF once for AM (MW)
rest of the world this step is 9 KHz. Usually the frequency stepY press RADIO ON-OFF twice to select FM
has been preset in the factory for your area.a STEREO appears on the display when you are receiving a
The tuning step on this set is also combined with the hour clockFM stereo transmission.
display where:3Select your station by one of the following:
10 KHz uses the 12-hr clocka by using the � TUNING + control (down or up);
9 KHz uses the 24-hr clocka pressing one of the Preset memory buttons 0-9 for a preset
station;
All preset stations will be lost and need to be programmeda Direct Access Tuning, by entering the known band
again when you change the tuning step.frequency.
4Adjust the sound with VOLUMEand DBB (Dynamic Bass
1In the radio mode, press and hold ENTER.Boost) controls.
a The radio station frequency will disappear from the5To turn off the radio, press RADIO ON-OFFonce or until the
display.display shows OFF and reverts to the clock mode.
2Without releasing ENTER, press and also hold down:
Y TUNING + (up) 5 seconds or more to select a tuning step ofTo improve reception:
10 KHz and the 12-hr clock.FM: The headphone cord functions as the FM-aerial. Extend it
a The display shows �UO briefly.fully and position the cord.
Y TUNING � (down) 5 seconds or more to select a tuning stepAM: Uses the built-in aerial. Turn the set to find the best
of 9 KHz and the 24-hr clock.position.
a The display shows �EO briefly.
6 |
ACEC
PHILIPS
