63 -09
PurposeSetting
Function Used to adjust the CCD gamma (CCD calibration)
(Purpose)(copy document mode).
SectionScanner (reading)
ItemPicture qualityColor balance
Operation/1. Set the SIT chart (UKOG-0280FCZZ) on the
63 -07Proceduredocument table, and make a copy in the manual
photo mode.
2. Set the copied SIT chart on the document table.PurposeSetting
Function Used to set the target color balance (gamma) for 3. Enter the simulation 63-9 mode.
(Purpose) auto color balance adjustment. The standard color 4. Press the [EXECUTE] key.
balance (gamma) or an optional color balance The color coefficient automatic adjustment pattern reading is
(gamma) is set as the service target.started to calculate and display the color coefficient data. The
SectionImage process (ICU)color coefficient data of each color can be displayed with the color
ItemPicture qualityColor balancekey.
Operation/1. In the copy color balance adjustment (manual
Procedureadjustment) (SIM 46-21) mode, the color patch
image (adjustment pattern) is outputted. (This
must be adjusted properly.)
2. Press the [SETUP] key.
3. Set the color patch image (adjustment pattern) paper printed in
the copy color balance adjustment (manual adjustment) (SIM
46-21) mode on the document table.
4. Press the [EXECUTE] key. The color patch image (adjustment
pattern) is read.63 -10
5. Press the REPEAT key and perform procedure 4 again.
6. Press the [OK] key.PurposeSetting
The color balance corresponding to the color patch image Function Used to set the copy document mode color balance
(adjustment pattern) printed in the copy color balance adjustment (Purpose)(gamma) default.
(manual adjustment) is set as the service target.
SectionScanner (Image scanning)
ItemPicture qualityColor balance
Operation/1. Press the [EXECUTE] key, and the [YES] and
Procedure[NO] keys become active.
2. When the [YES] key is pressed, the color balance value is set
to the default.
63 -08
PurposeSetting
Function Used to set the service target of the automatic color
(Purpose)balance adjustment (SIM 46-24) and the automatic
color balance adjustment target of the key operator
program to the same balance as the factory target of 63 -11
the automatic color balance adjustment (SIM 46-24).
SectionScanner (reading)PurposeSetting
ItemPicture qualityColor balanceFunction Used to set the factory color balance in the
(Purpose)automatic color balance adjustment (SIM 46-24).
Operation/1. Press the [EXECUTE] key.SectionScanner (reading)
Procedure2. Press the [YES] key.
With the above procedures, the service target of the ItemPicture quality
automatic color balance adjustment (SIM 46-24) and Operation/There are three kinds of color balance targets.
the automatic color balance adjustment target of the ProcedureSelect an optional color balance target.
key operator program are set to the same level as This setting is applied to the factory target only.
the factory target of the automatic color balance
adjustment (SIM 46-24).DisplayContentNOTE
DEF1Color balance with emphasis on color Default
reproduction (factory setting)
DEF2Color balance with slightly strong Cyan
DEF3Color balance with emphasis on Cyan
AR-C170M SIMULATION 9 - 63 |
ACEC
SHARP
