TD CARTRIDGE REPLACEMENT
If the machine detects an insufficient amount of toner being added, copyingFor best copying results, be sure to use only
will stop and the machine will add toner. During this time the START ()SHARP products.
key indicator will blink. When sufficient toner has been added the indicatorThe package of SHARP toner has the Genuine
will remain on steadily indicating that copying can be resumed. However,Supplies label.
if toner addition continues for a maximum of two minutes, the TD cartridge
replacement required () indicator will light up in addition to the START
( ) key being lighted steadily. This indicates that the toner supply is low
and a new cartridge will be needed soon. If copying is continued, the copies
will gradually become lighter until the copier stops and the TD cartridge
replacement required () indicator begins to blink, indicating that the
cartridge must be replaced. Replace the TD cartridge by following the
procedure below.
GENUINE SUPPLIES
Open the bypass tray. Lift slightly on the side cover
1and slide the cover out until it stops.
INDICATORS STATUS
Push gently on both sides of the front cover to open the
2cover.
TD cartridge replacement
Lift the TD cartridge lock release lever and pull theTD cartridge lock
release lever3cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
lFor disposal of the old TD cartridge, contact your dealer.
Remove the new TD cartridge from the bag. Hold the
4cartridge on both sides and shake it horizontally four or4 or 5 times
five times.
27 |
ACEC
SHARP
