AVR120 harman/kardon
Front Panel Controls
1
3029AUU�O y �
AVR 120
�
(
*
1
&
2
345 6 78 9 )! @$% ^
#
1 Main Power Switch! Input Source Selector� Set Button
2 System Power Control@ FM Mode Selectory Input Indicators
3 Power Indicator# Digital Optical 3 InputO Delay
4 Headphone Jack$ Digital Coax 3 Input� Digital Input Selector
5 Selector Buttons% Video 4 Video Input JacksU Main Information Display
6 Tone Mode^ Video 4 Audio Input JacksU Channel Select Button
7 Surround Mode Selector& Bass Control1 Speaker Select Button
8 Tuning Selector* Balance ControlA Test Tone Selector
9 Tuner Band Selector( Treble Control� Surround Mode Indicators
) Preset Stations Selector� Volume Control? Remote Sensor Window
1 Main Power Switch: Press this button to3 Power Indicator: This LED will be illumi-6 Tone Mode: Pressing this button enables
apply power to the AVR 120. When the switchnated in amber when the unit is in the Standbyor disables the Bass and Treble tone controls.
is pressed in, the unit is placed in a Standbymode to signal that the unit is ready to beWhen the button is pressed so that the words
mode, as indicated by the amber LED 3 sur-turned on. When the unit is in operation, theTONE IN appear in the Main Information
rounding the System Power Control 2.indicator will turn green. Should the indicatorDisplay U, the settings of the Bass & and
This button MUST be pressed in to operate theturn red, turn the unit off using the MainTreble ( controls may be used to adjust the
unit. To turn the unit off and prevent the usePower Switch 1 and check the speaker wireoutput signals. When the button is pressed so
of the remote control, this switch should beconnections to make certain that there are nothat the words TONE OUT appear in the Main
pressed until it pops out from the front panelshort circuits.Information Display U, the output signal
so that the word OOFF� may be read at thewill be Oflat,� without any bass or treble alter-
top of the switch.4 Headphone Jack: This jack may be used toation, no matter how the actual Bass and
listen to the AVR 120Os output through a pair of
Treble Controls &( are adjusted.
NOTE: This switch is normally left in the OON�headphones. Be certain that the headphones
position.have a standard 1/4" stereo phone plug. Note7 Surround Mode Selector: Press this but-
that the main room speakers will automaticallyton to change the surround mode by scrolling
2 System Power Control: When the Mainbe turned off when the headphone jack is in use.through the list of available modes. Note that
Power Switch 1 is OON,� press this buttondepending on the type of input, some modes
to turn on the AVR 120; press it again to turn5 Selector Buttons: When you are establish-
are not always available. (See page 22 for more
the unit off. Note that the Power Indicatoring the AVR 120Os configuration settings, useinformation about surround modes.)
3 surrounding the switch will turn greenthese buttons to select from the choices available,
when the unit is on.as shown in the Main Information Display U.
5 FRONT PANEL CONTROLS |
ACEC
HARMAN KARDON
